• Notice for iPhone users: DO NOT use the image size reduction option when uploading photos to the forum. This causes portrait images to post as landscape. We have added a warning to the image insert pop-up as well.

BB2 Carb Question Please

Wayne

Legacy Registered User
City
Cape Coral
State
FL
Hello:
I believe this is a BB2 Carburetor?
I am having issue with the fuel bowl, it keeps loosing prime. I took the cover of the bowl and noticed that one end of the wire that runs parallel with the two screw heads had got stuck under the gasket behind the hex screw. I thought a repaired the issue, I added fuel to the bowl and the Jeep started. I drove the Jeep for a few days with no issue.
The Jeep sat for two days. This morning she would not start - took the bowl cover of again, the cross pin was good, but the gasket was still raised behind the hex screw - The piece that goes up and down on the spring seems to be catching the gasket and raising it, I believe this is this why I’m losing fuel / prime in the bowl?
Would anyone know if it looks right?

Thank you,
Wayne.
IMG_1020.JPG
 
Hello:
I believe this is a BB2 Carburetor?
I am having issue with the fuel bowl, it keeps loosing prime. I took the cover of the bowl and noticed that one end of the wire that runs parallel with the two screw heads had got stuck under the gasket behind the hex screw. I thought a repaired the issue, I added fuel to the bowl and the Jeep started. I drove the Jeep for a few days with no issue.
The Jeep sat for two days. This morning she would not start - took the bowl cover of again, the cross pin was good, but the gasket was still raised behind the hex screw - The piece that goes up and down on the spring seems to be catching the gasket and raising it, I believe this is this why I’m losing fuel / prime in the bowl?
Would anyone know if it looks right?

Thank you,
Wayne.
View attachment 113579
Are you certain the wire goes there and not on the right (looking at your photo) side of the screw?
It appears that it is supposed to help guide the metering rods. :shrug: vacuum piston adjustment.png
 
Hello:
Like this?
Wayne,
I was going by the poor images I could find, and the description. I was thinking the the wire in your last pic should be on the right side of the screw and on the left side of the metering rods.
But you are there seeing it in real life. :shrug:

If you want to wait until tonight I can pull the cover off mine and snap a pic.
I don't think it's ever been touched, and "ran well when parked" :rolleyes:
 
Hello:
Like this?

That seems to match these pics I found...


pump-operated-vent.png
fuel-spark-203-jpg.2282793
 
Last edited:
So it looks like mt wire strands are wrong.
Thank you very much.
 
Wayne,
I was going by the poor images I could find, and the description. I was thinking the the wire in your last pic should be on the right side of the screw and on the left side of the metering rods.
But you are there seeing it in real life. :shrug:

If you want to wait until tonight I can pull the cover off mine and snap a pic.
I don't think it's ever been touched, and "ran well when parked" :rolleyes:
Well, if it's not that much bother It would be truly appreciated.
 
Regarding the vacuum piston should it be loose? It is still catching the gasket even after changing position of the wires?
 
Back
Top