Wayne
Legacy Registered User
- City
- Cape Coral
- State
- FL
Hello:
I believe this is a BB2 Carburetor?
I am having issue with the fuel bowl, it keeps loosing prime. I took the cover of the bowl and noticed that one end of the wire that runs parallel with the two screw heads had got stuck under the gasket behind the hex screw. I thought a repaired the issue, I added fuel to the bowl and the Jeep started. I drove the Jeep for a few days with no issue.
The Jeep sat for two days. This morning she would not start - took the bowl cover of again, the cross pin was good, but the gasket was still raised behind the hex screw - The piece that goes up and down on the spring seems to be catching the gasket and raising it, I believe this is this why I’m losing fuel / prime in the bowl?
Would anyone know if it looks right?
Thank you,
Wayne.

I believe this is a BB2 Carburetor?
I am having issue with the fuel bowl, it keeps loosing prime. I took the cover of the bowl and noticed that one end of the wire that runs parallel with the two screw heads had got stuck under the gasket behind the hex screw. I thought a repaired the issue, I added fuel to the bowl and the Jeep started. I drove the Jeep for a few days with no issue.
The Jeep sat for two days. This morning she would not start - took the bowl cover of again, the cross pin was good, but the gasket was still raised behind the hex screw - The piece that goes up and down on the spring seems to be catching the gasket and raising it, I believe this is this why I’m losing fuel / prime in the bowl?
Would anyone know if it looks right?
Thank you,
Wayne.




