• Notice for iPhone users: DO NOT use the image size reduction option when uploading photos to the forum. This causes portrait images to post as landscape. We have added a warning to the image insert pop-up as well.

Bumpers for glovebox door?

Manhattan

Legacy Registered User
City
Atlanta
State
GA
Building a Jeep from scratch can be a hassle... it's the little things. Here's today's:

Does a factory dash have any "bumpers" or rubber grommets as shown in this pic?

Note: not my dash... a grab from the inter webs
glovebox.jpg


Thanks!
 
Two tiny rubber nipples go in the upper corners, so the door dosen't rattle against the dash.

No rubber where the lock goes.
 
They look like this:

Screen shot 2012-08-02 at 3.32.07 PM.png

And are roughly $5 each.

Joe
 

Attachments

  • Screen shot 2012-08-02 at 3.29.14 PM.png
    Screen shot 2012-08-02 at 3.29.14 PM.png
    37.9 KB · Views: 80
I read on another forum that the bumpers are the same (or close enough) on a Ford truck gas fill door.
 
It looks like the one on my Expedition would work (or my old Bronco). So you might be right.
 
I made a bunch of wooden cutting boards and used a cheap packet of bumpers as feet on the bottom side. I think i got the bumpers at Lowes and they had several sizes/styles. They were maybe $1.25 for a packet of 4. Local hardware store had them too but they have gone out of business.
 
Thanks guys. I may just scrounge around Home Depot or Lowes for some small stick-on pads. They could go on the glove box door - instead of the dash. Really wondering why I designed the dash with a *#$&ing glove box at all. The heater takes up so much room... it's a pretty useless little space.
 
Back
Top