- City
- charlotte
- State
- nc
A few months ago, I replaced the stock carb with an MC2100. In the process of removing and replacing vacuum lines i broke the nipple off my evaporation (charcoal) canister. I couldn't figure out an easy fix and I didn't want to eliminate it like some do, so I decided to replace the canister. The purge valve on these canisters is susceptible to dry rot and that can cause a vacuum leak- so I wanted a new vs. used one.
It didn't take long to figure out direct fit replacements are not available. I spent a fair amt of time researching and reading multiple forums looking for an alternative. Each time I found a write up with model number, the model was discontinued. I found some threads on IFSJA where guys had used a GM replacement (Napa Part# crb 229805). this unit is bigger, so the bracket has to be modified and it has two purge valves- the unused would be capped. I ordered this unit- unfortunately I just upgraded my brake booster/ MC and the brake lines would not allow it slide in to place. Long story short I ended up digging some more and found a replacement Advanced Auto Parts #cp1109. This cannister has the needed connections, but is a smaller diameter than the stock. It has a sealed bottom with breather port, which seems better than the open filter material on the stock canister. To make it fit the stock bracket, I bought a 4" rubber pipe coupling and cut it into two strips- this provides a spacer that allows the stock bracket to grip the canister.
I haven't driven it a ton, but it seems to be working great so far- and there is no gas smell in my garage.
Evaporation canister replacement is not the most exciting project, but maybe this will help someone out who is searching for a replacement.
Here are some pics.
Original vs. New Comparison

New-top view

New w/ Spacer before cutting spacer

Installed


It didn't take long to figure out direct fit replacements are not available. I spent a fair amt of time researching and reading multiple forums looking for an alternative. Each time I found a write up with model number, the model was discontinued. I found some threads on IFSJA where guys had used a GM replacement (Napa Part# crb 229805). this unit is bigger, so the bracket has to be modified and it has two purge valves- the unused would be capped. I ordered this unit- unfortunately I just upgraded my brake booster/ MC and the brake lines would not allow it slide in to place. Long story short I ended up digging some more and found a replacement Advanced Auto Parts #cp1109. This cannister has the needed connections, but is a smaller diameter than the stock. It has a sealed bottom with breather port, which seems better than the open filter material on the stock canister. To make it fit the stock bracket, I bought a 4" rubber pipe coupling and cut it into two strips- this provides a spacer that allows the stock bracket to grip the canister.
I haven't driven it a ton, but it seems to be working great so far- and there is no gas smell in my garage.
Evaporation canister replacement is not the most exciting project, but maybe this will help someone out who is searching for a replacement.
Here are some pics.
Original vs. New Comparison

New-top view

New w/ Spacer before cutting spacer

Installed



