• Notice for iPhone users: DO NOT use the image size reduction option when uploading photos to the forum. This causes portrait images to post as landscape. We have added a warning to the image insert pop-up as well.

Cracked Waterjacket

breckwrecking

Narrow Tracker
City
Kittery
State
ME
Ive been leaking oil for a bit when i make left hand turns and noticed the gasket for the valve cover was pushed in a little bit on the driver side. So today i went to take the valve cover off and undid the front driverside bolt and antifreeze started pouring out. Needless to say, i just tightened the bolt back up and left it for the time being. Is this normal? I had a shop around here tap the two holes on the driverside to put the aluminum valve cover on. Is this normal or were the bolts overtightened? From here what are my options? New head? Different options im not aware of? Thanks for the ideas in advance.
 
Somebody drilled too far when they put the valve cover on. Just put a stud in there with some sealer and it'll be alright...
 
Not normal. But, only leaking oil when you turn left is odd too. Did you notice it by seeing smoke when you turn left? If so, probably leaking all the time and only runs into exh manifold and smokes when it puddles up and you turn left.
You can:
- fix valve cover gasket , put the bolt back in and drive it
- fix valve cover gasket, put stud where bolt is and drive it
- remove the head, drill the hole larger and insert a blind helicoil in it. Then put it back on, and drive it.
- swap the head

I would take it apart some more and look in the hole with a light. If it is in fact only the water jacket breached; and there is no oil in your water and no water in your oil; I would probably just fix the gasket and put the bolt back in with a little sealant around it. Then watch for oil/water contamination (which may never happen).
 
Last edited:
Not normal. But, only leaking oil when you turn left is odd too. Did you notice it by seeing smoke when you turn left? If so, probably leaking all the time and only runs into exh manifold and smokes when it puddles up and you turn left.
You can:
- fix valve cover gasket , put the bolt back in and drive it
- fix valve cover gasket, put stud where bolt is and drive it
- remove the head, drill the hole larger and insert a blind helicoil in it. Then put it back on, and drive it.
- swap the head

I would take it apart some more and look in the hole with a light. If it is in fact only the water jacket breached; and there is no oil in your water and no water in your oil; I would probably just fix the gasket and put the bolt back in with a little sealant around it. Then watch for oil/water contamination (which may never happen).

X2 Exactly what I would do
 
I have a couple of studs in the old 258 for the cover. It made it easy to line up the gasket and cover. Definitely what I would do. Only thing is to watch the clearance for a socket on the nut. Mine ended up too tight and I tapped out a smaller nut to get enough room for the socket to get on it. Not an issue on every hole but FYI
 
Back
Top