• Notice for iPhone users: DO NOT use the image size reduction option when uploading photos to the forum. This causes portrait images to post as landscape. We have added a warning to the image insert pop-up as well.

Dana 300 whine

Ron84cj

Engine nerd
Lifetime Member
City
West Bend
State
WI
My Dana 300 is quite in high range, but in low the gears really whine. I've had the cover off and there wasn't anything noticably wrong inside. The gears all looked nice. So hoping it was just the fuild I filled it up with fresh stuff but no difference. Is this normal for these things?
 
It will do it anytime I go faster than 5 to 10 mph. At least that is when I start to hear it.
 
The D300 was actually one of the quietest gear driven T/Cs made due to the helical gears and splined input. What kind of gear oil did you use?
 
Last edited:
Valvoline 80w 90. The Jeep I got this out of I wouldn't be a bit surprised if it had never been in 4wd or 4 low at all. It had the little 205-75R15 tires on it for it's whole life. Some fire department used it for really light duty use. Maybe the bearings got damaged from sitting?
 
I'd be surprised if it were bearing noise.

Everything spins in high and low, so bearing noise would be present in both conditions (although maybe at a higher speed in high).

You've looked inside, and it looks good. You've got fresh gear oil. I'd run it as-is for a while, and if it doesn't get louder, then that's the way it is.

It's very unlikely that you'll have a catastrophic failure.
 
Don't think the oil is suspect. If it sat for a prolonged period (especially with any moisture in the case), there may have been some rust built-up that could be a problem. But, sound is pretty subjective, so I wouldn't go tearing things apart just yet. What seems quiet to me (I'm thinking in terms of comparison to something like my T18 in reverse), may seem loud to you. I'd try to find another Jeep with D300 in your area to see if it sounds similar or not. If it is making more noise than it should, I'd try to figure out why before it gets worse (an ounce of prevention...)

Just my .02
 
Valvoline 80w 90. The Jeep I got this out of I wouldn't be a bit surprised if it had never been in 4wd or 4 low at all. It had the little 205-75R15 tires on it for it's whole life. Some fire department used it for really light duty use. Maybe the bearings got damaged from sitting?

Maybe it's just getting broken in?
 
Don't think the oil is suspect. If it sat for a prolonged period (especially with any moisture in the case), there may have been some rust built-up that could be a problem. But, sound is pretty subjective, so I wouldn't go tearing things apart just yet. What seems quiet to me (I'm thinking in terms of comparison to something like my T18 in reverse), may seem loud to you. I'd try to find another Jeep with D300 in your area to see if it sounds similar or not. If it is making more noise than it should, I'd try to figure out why before it gets worse (an ounce of prevention...)

Just my .02

That's actually exactly what it sounds like. When you are in reverse with a manual transmission, only louder.
 
Back
Top