• Notice for iPhone users: DO NOT use the image size reduction option when uploading photos to the forum. This causes portrait images to post as landscape. We have added a warning to the image insert pop-up as well.

Diagnosis Help From My Scrambler Friends

wannascram

Scrambler Rookie
Lifetime Member
City
Dripping Springs
State
TX
I have an 82 with the I6 (258) and 3 speed auto. Been driving daily since August of 15 when I bought it.

Wondering if any of you mechanically inclined folks would be kind enough to to give me a sense for what I might be looking at...

So here goes... During my daily driving, she runs smooth and drives well. Especially during the warmer months as I'm getting around, if I sit idle (like at a traffic light) the temp gauge starts creeping up. Resume on down the road and it goes back down to normal temp level (beginning of the green indicator). Presumably this is resulting from air flowing through. Stop again and she heats up. Never taken her further than about halfway through the green indicator line and never truly/fully overheated her.

I took the cap off the radiator over the weekend and watched from essentially cold to having idled for a few minutes (enough time to get to "running" temp).

Can see that I'm getting "flow" through the system (though it may need to be flushed and cleaned). Coolant has foamy consistency and has a slight brown color which I'm thinking this is as it picks up sediment and dirt from the bottom during circulation).

Is the thermostat not kicking in until a higher temp? Pump not flowing enough to cool at idle?

Also, and this is something that I haven't fully tested yet... Wondering if in park at idle and it heats up to higher if only giving it some gas would increase engine RPM and either activate thermostat and/or increase pump flow to vitals and increase cooling.

Seems to be a bigger issue in warmer months vs. colder (by TX standards)... If that changes anything.

TIA for anyone who knows more than me and is willing to share.



Sent from my iPad
 
Can you elaborate on what you mean by "wrong cap" and yes, it probably could use a flush job.



Sent from my iPad
 
Actually after thinking about it, sounds like it may be running the wrong thermostat, but I would do a thorough flush first.
 
I am not an expert, but if you are getting flow through the system (radiator) your thermostat is functioning (as far as I understand it) to some degree. Is your fan working? If so does it have a shroud? When it is heating up, is it just moving off of cold or getting into the "red", since you really aren't overheating in the green zone unless you see steam or other indicators? There are different "temperature" thermostats so depending on what one you use I imagine it will impact where in the green zone you run before cooling starts.

Mine typically will run about halfway through the temp indicator green zone until the fan kicks on, but I do have a different set up with an electric fan and different engine. For an electric fan, it doesn't kick on until you hit a certain temperature (not sure of a clutch on mechanical fan), and driving down the road essentially represents the effect the fan would give you when running.

I am probably way off but figured I would offer that up.
 
Mine acted that way when I had air trapped in the system. After a good burping (by bouncing the front bumper a lot) I was able to get the air out and top it off. Things got much better.

It started again when I replaced my heater core. Burped it again and all was better.

When you do a flush, make sure you get all of the air out.

Good luck
 
I don't know if you have a clutch fan. If you do the clutch could be bad and slipping (not allowing the fan to rotate at correct speed). If not it sounds like the radiator (could be gummed up and not allowing the coolant to flow through all tubes or reduces the amount that flows through). Are the fins of the radiator clean and in good condition? I've had this happen on cjs and regular cars, replace the radiator and problem solved.
 
Last time I flushed a radiator in a jeep it blew it open and I ended up having to replace a radiator. Ymmv
 
I am not an expert, but if you are getting flow through the system (radiator) your thermostat is functioning (as far as I understand it) to some degree. Is your fan working? If so does it have a shroud? When it is heating up, is it just moving off of cold or getting into the "red", since you really aren't overheating in the green zone unless you see steam or other indicators? There are different "temperature" thermostats so depending on what one you use I imagine it will impact where in the green zone you run before cooling starts.

Mine typically will run about halfway through the temp indicator green zone until the fan kicks on, but I do have a different set up with an electric fan and different engine. For an electric fan, it doesn't kick on until you hit a certain temperature (not sure of a clutch on mechanical fan), and driving down the road essentially represents the effect the fan would give you when running.

I am probably way off but figured I would offer that up.

I appreciate that. The fan runs and is shrouded. Runs all the time, assuming like you mentioned that there's not a clutch. If I think about it this weekend I may try and post a picture of the gauge. Based on what I've seen the gauge is stock. Black space (no line for first 1/3 of indicator then green line for the remainder.



Sent from my iPad
 
Mine acted that way when I had air trapped in the system. After a good burping (by bouncing the front bumper a lot) I was able to get the air out and top it off. Things got much better.

It started again when I replaced my heater core. Burped it again and all was better.

When you do a flush, make sure you get all of the air out.

Good luck

Good call, it probably does need a flush and clean with new fluid. Never heard of or thought about burping it (I guess kind of like bleeding a brake line). Also worth noting that my overflow reservoir seems to stay empty all the time...


Sent from my iPad
 
I don't know if you have a clutch fan. If you do the clutch could be bad and slipping (not allowing the fan to rotate at correct speed). If not it sounds like the radiator (could be gummed up and not allowing the coolant to flow through all tubes or reduces the amount that flows through). Are the fins of the radiator clean and in good condition? I've had this happen on cjs and regular cars, replace the radiator and problem solved.

I haven't popped it off to see other than what you can through the cap. Fluid is admittedly a bit dirty and seeing what looks like hard water clumps/buildup. Sounds like a flush is in order. Just hope I don't make the mistake that walkerhoundvvm did... Ouch!



Sent from my iPad
 
Could be the radiator is slightly plugged and setting at idle its not getting enough flow, and when you speed up its better..

You should not have clumps or build up in the radiator so I would think a good flushing is in order...When flushing do the reverse flush of just the heater core first, pull off both header hoses you wont believe how much crud will come of it. Radiator might need to be boiled out or replaced.

if the thermostat is old, just replace it, its the easiest and most cost effective fix in the cooling system. As long as your cleaning up and changing the fluid why run an old thermo which could go bad the day after you do all this work. It could though last the life time of your truck...

Good luck
 
Take rad to a radiator shop, have them rod it out and clean it up. Then put it back on with new coolant.
 
Back
Top