• Notice for iPhone users: DO NOT use the image size reduction option when uploading photos to the forum. This causes portrait images to post as landscape. We have added a warning to the image insert pop-up as well.

Door assembly instructions?

Skeltor

Basic User
City
Flagstaff
State
Az
Does anyone have assembly instructions for hard doors. The previous owner disassembled them to clean up some rust. I think I have the parts I need, but some instructions would be helpful.
I tried searching the forum and didn't find anything.
Thanks


 
Thanks for the link! That's pretty good, I should be able to get these doors back together with that.


 
The trickiest part is getting the wedge in that keeps the exterior handles in place. Take your time & do it right or you'll have to take it apart in a few months & wedge it in there again.


 
I took apart a door handle 18 years ago probably and never could get the wedge back in, sold it apart after I bought a better pair of doors.
 
I already mounted the exterior handle on the driver side door. I thought the serrated wedge pieces were pretty clever. What is concerning to me is all the linkages that tie the different components together. Maybe I just have to do it for it to make sense.


 
I received a set of hard half doors painted to match when I purchased my Scrambler.

The issue was however that the painter lost all the mechanical components to the doors so all I have now is a set of doors with no mech's in them... I looked for years and then ultimately found a another set painted Chrysler Flame Red lowers that matched my Jeep so I bought those instead. Now that I have the black Jeep I am looking for a thrashed set of lowers so I can rob the mech's and get the doors painted to match the new Laredo. What a hassle!
 
If you have one complete together, put them aide by side and make the empty one look like the full one. Kinda like when doing drum brakes(for me anyway since I do not do them often)
 
Turns out I don't have all the parts I need. I purchased new lock cylinders online and they came with a lever arm that is flat. The lever arm needs to be shaped more like a "Z" with the slanted piece actually being vertical. Can't seem to find the correct lever arms online. Does anybody know where to buy them or a suitable substitute, or has anybody made them. I might try making them if I can't buy them.


 
Back
Top