• Notice for iPhone users: DO NOT use the image size reduction option when uploading photos to the forum. This causes portrait images to post as landscape. We have added a warning to the image insert pop-up as well.

Door striker adjustment

Grey Fox

SOA Member
Lifetime Member
City
Bountiful
State
UT
I'm wanting to move the door striker pin (Horizontally). Before I dig into it, it never hurts to get a quick how to lesson from somebody. Thanks
 
Not real sure what your question is....the door striker on the removal is pretty straight forward. There are 3 to 4 bolts that hold the whole thing on the body.

Good Luck
SC
 
Sorry if my initial statement was illusive. When latched, one of my doors sits out 1/4" from being flush to the body. I'm thinking if there is an adjustment on the striker pin to move it inward it will draw the door in so that its flush to the body. Maybe the pin doesnt even adjust that way:confused:
 
Now I get it

Ahhh.. much better. Mine does the same thing, but my doors are from a YJ and are half doors. You can loosen the striker pin a bit and then tap it inward. Then tighten the pin while holding it from wanting to walk back out. I'm not sure how much adjustment you will have, but for me its not quite enough. Mine were pretty messed up anyway because the guy that owned the Jeep before me had the tow bar fall down while driving on a dirt road. It slightly bent the frame up and compressed the full doors. That messed up both strikers. I should have bought new ones but took them off and pounded them as best I could to re-shape them.

Don't loosen them up too much or the shims may fall out.
Good luck and let us know if it works for you.
 
Ok that's my question, how the striker pin loosens and adjusts. Slims? This is probably a ridiculously easy process but I've broke 2 of the T20 torx bits just trying to get the cover off of the striker body due to those little rusted and seized screws. Do I even need to get that cover off ? I see on the outside there is a jam nut collar on the pin. Is it as easy as loosen that? Its just that I've been hell bent on getting that cover off, I'm probably over looking the simplicity of it. I'm picking up more torx bits today so I'll have that cover off tonight (one stubborn screw left). Once I get it off I'm sure I'll see how the whole thing works.
 
Grey Fox said:
Ok that's my question, how the striker pin loosens and adjusts. Slims? This is probably a ridiculously easy process but I've broke 2 of the T20 torx bits just trying to get the cover off of the striker body due to those little rusted and seized screws. Do I even need to get that cover off ? I see on the outside there is a jam nut collar on the pin. Is it as easy as loosen that? Its just that I've been hell bent on getting that cover off, I'm probably over looking the simplicity of it. I'm picking up more torx bits today so I'll have that cover off tonight (one stubborn screw left). Once I get it off I'm sure I'll see how the whole thing works.

The striker pins are secured by some blue locking compound. When I moved mine, I removed the entire assembly and gently heated the back part of the striker with a propane torch and they unscrewed easily. The "cover" is actually what the striker screws into, so it should come off if you're going to use heat.
 
Last edited:
I just used a good pipe wrench on mine....worked great unless you are looking for show room quality.


Good Luck
SC
 
Back
Top