• Notice for iPhone users: DO NOT use the image size reduction option when uploading photos to the forum. This causes portrait images to post as landscape. We have added a warning to the image insert pop-up as well.

Exhaust and Air Intake Systems?

KnightJack

Legacy Registered User
City
Mckinney
State
Tx
I am looking at ditching the 30year old exhaust system (piping, cat, muffler), since I just installed a new Inline 6 on my Scrambler and was looking for some good ideas of what I should replace it with. I also would like some ideas on Air intake systems and if Cold Air Intake Systems are worth it. Thanks.
 
Congrats on the motor:thumbsup:........I went the inexpensive route and just bought all the parts at Autozone. I think it cost less than $100 to redo. I did have to weld the cat because it was a little bit of a loose fit and looked like a clamps would not seal it.

FrameExhaustJPG-1.jpg
 
Howell TBI kit

I am installing the Howell TBI kit and if anybody has done this? If so, what air intake system do you have installed?
 
late response..

on my Howell TBI I had a standard chrome air cleaner sitting on top of the throttle body, just like a carb.. I can't remember if the Howell instructions told you which one to get but, went to local Autozone (or similar) and found a Moroso or Mr Gasket or something like that..
 
intake set up

Here are two different set ups I'm running on my 8 with the howell fi.
 
There are a couple of places on eBay that have them. Look for one for a Chevy Pick Up with TBI. Something like a 94-95' c/k2500.


Carl
 
intake kit

The kit I used for the intake was an Airaid part number is #200-104, if I remember right I bought the kit from my local Advance Auto Parts or Auto Zone. I'ts for a 1988 1995 Chevy V8 305 & 350 TBI. Hope this helps.
 
thanks

thanks for the info will check on it next week:cheers:
 
Back
Top