• Notice for iPhone users: DO NOT use the image size reduction option when uploading photos to the forum. This causes portrait images to post as landscape. We have added a warning to the image insert pop-up as well.

Floor plugs for body mount bolt access?

bigwalton

Alaskan Postal nutjob
FORUM MANAGER
SOA Member
City
Dexter
State
MI
If I rework my stock tub, I want to put in holes for proper nuts on the body mount bolts with the largest possible plates on each spot. The idea of putting in crappy loose captured nuts in flimsy cages that will eventually go wrong again is silly to me.

Just saw these and thought they might be perfect for most of the locations. Anyone else gone down this road with something similar?

3E1E3769-CB41-4250-8DA3-225E85D1ED43.jpeg

I’m also doing a door for in-tank fuel pump/line/sending unit access, so originality is out the window.
 
First, I love this idea and approach. Capture nuts drive me insane. The question on my mind is are these steel or aluminum or something else? Would you have to worry about Galvanic corrosion due to dissimilar metals?
 
First, I love this idea and approach. Capture nuts drive me insane. The question on my mind is are these steel or aluminum or something else? Would you have to worry about Galvanic corrosion due to dissimilar metals?
Good point. Would have to check. Plastic was what I was thinking until I saw these.

I did this already on the one body mount that broke and just covered the hole I cut with black duct tape (under driver’s seat) and I LOVE having that access.
 
These are metal and have a rubberish type seal. That’s what you see that is off white in the pic. AMC actually used this exact plug on the CJs towards the end of the run and then YJs too
 
These are metal and have a rubberish type seal. That’s what you see that is off white in the pic. AMC actually used this exact plug on the CJs towards the end of the run and then YJs too
Now that i look at these more, are they locking where you’d need access to the prongs to get them out? Or are they made to be removable from on top?
 
Now that i look at these more, are they locking where you’d need access to the prongs to get them out? Or are they made to be removable from on top?
They pop out from the top, the prongs are a bit spring loaded and do take some force and on the originals prying out with a screw driver does mess the seal some. These are also painted over from the factory, not ideal and not really designed to take in and out although you could.
 
The reality is that they're not needed to be taken in and out that often. I may get one to play with in advance.

I could cut a hole in the area I'll be removing for the fuel pump access door...
 
First, I love this idea and approach. Capture nuts drive me insane. The question on my mind is are these steel or aluminum or something else? Would you have to worry about Galvanic corrosion due to dissimilar metals?
Good point. Would have to check. Plastic was what I was thinking until I saw these.

I did this already on the one body mount that broke and just covered the hole I cut with black duct tape (under driver’s seat) and I LOVE having that access.
Something like this might fit the bill...
(this same 2" size fits 22 - 14 gauge metal)

 
Back
Top