• Notice for iPhone users: DO NOT use the image size reduction option when uploading photos to the forum. This causes portrait images to post as landscape. We have added a warning to the image insert pop-up as well.

Glove box lock fix

cbford

Legacy Registered User
City
CLT
State
NC
So, I had a locking glove box latch, like this:

s-l1600.jpg

But the handle was gone when I got the jeep. Only the lock/cylinder was left. And it didn't work well that way.

I wanted to be able to open the glove box and didn't want to spend $30 or $40 to fix it. Here is what I did.l
 
Use the end of a small cotter pin in the hole on top of the housing to press down the lock pins and remove cylinder.

7904-1122-GLOVEHOUSE2.jpg
 
Now you have this:

small lock cylinder 2.jpg

And I bought one of these headlight knobs for $4 to put on it.

zw-1331806.gif
 
I removed lock pins, including retaining pin for cylinder.
Only retaining pin is shown in this picture:

small lock cylinder.jpg

Then I measured depth of lock cylinder. Cut new knob to length.
Then filed the point of the triangle so the shaft would fit snugly in key slot and press to bottom of lock cylinder.

new handle end view.jpg
 
I also marked the location of the retaining pin on the new knob shaft, and filed an indent so I could put the retaining pin back in cylinder around the new knob shaft. Like this:

new handle top.jpg
 
Then I put some Permatex metal repair epoxy in the pin slots top and bottom to make sure things stay put. You can see I stopped short of the retaining pin.

new handle epoxy.jpg

So the retaining pin moves up and down on the tiny spring like it should, meaning you can install/remove the cylinder to the lock base as AMC intended.
And the whole assembly will turn freely, and work as before other than it no longer locks.

new handle installed.jpg

At least it matches the other handles.
 
That works! I have the same lock cylinder on mine. Locked and unlocked fine but getting the door open was a problem. I finally cut two thin pieces of grip tape (think skateboard) and put a thin strip on either side of the knob. Gave just enough traction to pull the door open while turning the knob.

I like how yours matches the dash knobs.
 
Back
Top