• Notice for iPhone users: DO NOT use the image size reduction option when uploading photos to the forum. This causes portrait images to post as landscape. We have added a warning to the image insert pop-up as well.

HD AMC 20 gurus... pinion shim question

Randyzzz

Blown Budget
BENEFACTOR
Gold Member
Lifetime Member
SOA Member
City
Redmond
State
OR
Finally getting my rear axle built, but have run into a snag. The original pinion had a single .096 shim between the inner pinion race and the housing. The new gear set/bearing set wants me to put shims between the pinion head and bearing. I'm thinking if the factory liked the shims at the race, that's where they should go. What's your advice?
 
I put mine behind the race.

I believe that the bearing is pressed on. If you put the shim behind the race you don't have to press the brg on and off to set the depth. Just take the race in and out. Just make sure that the race is fully seated.

I'm no expert, but mine hasn't blown up yet.
 
TravelnMan said:
I put mine behind the race.

I believe that the bearing is pressed on. If you put the shim behind the race you don't have to press the brg on and off to set the depth. Just take the race in and out. Just make sure that the race is fully seated.

I'm no expert, but mine hasn't blown up yet.


exactly...but if u decide to shim the bearing..hone the old one till it is a slip fit...and set the pinion with the old bearing..then when u get it right ...press the new bearing on
 
scott anderson said:
we got a honing machine at work...lol..much easier
Me too! It's called a wheel cylinder honing machine and I was the machine!:D ;)
 
Thanks guys. My preference is to shim behind the race- seems like the factory method makes the most sense. Now I just have to find a shim set...I've called several reputable shops only to be met with confusion!:confused:
 
Randyzzz said:
Thanks guys. My preference is to shim behind the race- seems like the factory method makes the most sense. Now I just have to find a shim set...I've called several reputable shops only to be met with confusion!:confused:

i got tons of shims..give me the id and od and i will send all i got that size to you..my stuff is all one ton now..i dont have any need for them
 
Scott- thanks! I'll get a measurement (I left the old shim at work) but I seem to remember 3.120 od and 2.50 id. I'll try and get exact measurements tomorrow. :bow: :bow: :bow:
 
cool...you are welcome to all i got..if i dont find many..i will go to my cousins shop ..he has thousands
 
Scott- one of the local guys got me a handful- but thanks anyways. Now I just have to light a fire under the guy putting it together. AARGH!
 
Back
Top