• Notice for iPhone users: DO NOT use the image size reduction option when uploading photos to the forum. This causes portrait images to post as landscape. We have added a warning to the image insert pop-up as well.

How much will it cost?

Gueon

Scrambler Junkie
Lifetime Member
City
Thatcher
State
AZ
I am looking to change out the gears in my axles to better accommodate the 258, T5, D300, 35" combination that I am running. What should I expect to pay for the gear set and labor? Will I need a new carrier or just the ring and pinion? The axles are stock 20/30's.

:shrug:
 
You will need new carriers for both the 20 and the 30. Ratio break on them is 3.08 and 3.54 respectively.

In my opinion, 4.56 gears will give you a nice all around drivable rig. More serious offroad intent, you will want 4.88. 4.10 would still mean 5th gear on highway only with no big hills or headwind.

Also, if you are thinking lockers, this is the time to do it.

Go here: http://www.ringpinion.com/ and read up. He has great calculators on the web page and showed me great service on several purchases.

Depending on what you choose for carriers/lockers, gear sets, axles, etc.... figure on $1,200 - $3k.
 
I was quoted $2000 for just a gear change [no axles, lockers, etc.], which seems a bit steep to me... I hate to spend that kind of money on the 20 & 30 when I would like to upgrade them down the road. That's money that I will not get back.

Scramfrog, as I recall you have a fairly gnarly set of axles, Dana 60's if remember correctly. You could not go wrong regearing those, they will last forever. Mine on the other hand, not so worthy.
 
I can understand that statement. I ended up buying scout axles with 4.10's in them. The install will be require labor for me but that is just sweet equity on my behalf and cheeper than regearing the stock axles.
 
Find a local Jeep Club. Internet can help there. Get in touch with the president. He will know a "wrench" in his group that does stuff like this on the side. Before you commit, pay a visit to his shop and look around. This tell you alot about the level he can work to.

This has worked for me in the past. I don't have tools to do my Dana 300. I will go this route with mine. It's good to build a relationship with other jeepers in your area.
 
look for a used set...usually you can get them for 200-300. If you find someone parting a 4cylinder, those are usually 3.73's or 4.10's....cheapest way I know.

Best of luck!
 
x2 on finding axles. My buddy just sold his D30/AMC20 with 4.10's, ARBs, Warn full float rear and Warn internal hub kit front for $1200. I found a D44 rear with 4.88 and Detroit for $600.
 
Back
Top