I just wanted to give a little update on this project. I am not much for writing a ton of things since I mainly only spend time on a computer for work. I haven't updated since last year but I did get some work done.
1. Rebuilt the heater system and installed it.
2. I put the dash together and installed it.
3. Rebuilt the steering column and installed.
4. The seats got installed and brackets cleaned up.
5. Prepped and applied the U-Pol Raptor liner on the interior.
6. Finished the front steering with a tie rod flip and all new parts and applied POR-15 to both axles.
7. Cleaned up and painted the springs and replaced the bushings.
8. Bought a Cage kit from Extreme Customs and I am about finished with the fitting and final welding. I will remove the cage this week to prep and paint it. The whole thing is getting tied to the frame including the part tied to the dash. I didn't want to use the dash kit but there were way too many compromises with having the downtube in front of the dash. I am building a plate for the back side and will have the down tubes tucked in behind the dash.
9. I am mocking up the armor plating so I can drill the holes needed and plan to get them either painted or powder coated in the next month.
After these items are buttoned up then I need to fix the paint on my doors and assemble them for final install. I have to finish up the rear disk brake conversion after some fitting show up and install the longer rear wheel studs. Once this is done then I have the winter to get the motor and driveline put in.
Anyway here are the pictures.
