• Notice for iPhone users: DO NOT use the image size reduction option when uploading photos to the forum. This causes portrait images to post as landscape. We have added a warning to the image insert pop-up as well.

O?T tires for fullsize

taildragger

Bow Hunter
City
Norman
State
OK
I am looking at getting new tires for my full size and was wondering how bad the effect of going to a kumho might be on my mileage vs getting a set of BFG A/T. Also, are there any other AT's other than the BFG's that are decent off-road. I use this truck a lot for hunting, so I will see some decent mud every now and then.
 
I've had 5 sets of Cooper Discoverer AT's on various vehicles from CJ's to full-size vans and get nothing shy of amazing mileage (wear). Quiet on highway and run cool. Simply, the best all-around on/off road tire I've owned. IMHO
Paul
 
Also have to ask what size truck, size tire, and how heavy of loads you carry. I'm getting ready to replace the tires on my 1-ton and have ruled out the BFG-AT/KOs since while they are great on a light vehicle like a 1/2 ton truck, they just don't stand up to long wear under heavy loads. So, I'm going to go back to my BFG Rugged Trail which have provided over 50K mile service, 40% of which was towing over 1,500 pound pin weight.
 
Absolutely, What weight you carry is probably the most important factor. I had the Coopers on a 1-Ton Econoline, but I wasn't loading heavy. However these tires are available all the way to E rating.
Paul
 
These are for a 3/4 ton. Usually I run empty, but will occassionally pull a trailer (so far the most is somewhere around 10,000lbs).

Mileage was in referrence to MPG and mileage for the tires.

I was looking at getting something like a 235/85/16 or a 255/85/16

BTW, I have found both tires for E load range
 
Last edited:
I just swapped to the ProComp AT in 265/75/16 on my K2500.

They are nice and smooth riding with decent light mud traction. Seem to be wearing fine too.

Now this is saying a lot for me to praise anything from ProComp since I hate their Mud Tires so much. Probably one of the worst wearing tires on the planet.

Carl
 
For that size tire, you may want to look at the Michelin LTX M/S. I ran them before on my old 1-ton and they did fine. Never got into much goo with them as it was mainly a tow rig, but did do enough exploring to be satisfied. If they were offered in a 265/70R17E I would be running them now.

The tires may be a bit more expensive than others, but if you rotate them about every 10K, reports say you should get about 80K+ from a set of tires.

I also ran the bridgestone dueller at on my old truck before switching to the Michelin's. They did a little better than the michelin's, were quiet and they provided about 60K miles. May be a little better suited for the hunting club.

When thinking about my comments, remember, I look at reliability, longevity, then traction under heavy loading conditions.
 
I'm giving the Toyo Open Country MTs a shot on my 1997 Dodge Ram 2500. They and the Hankook Dynapro MT RT103 were the only tires I could find with Load Range E, 10 ply rating in 315/75/16 size.
 
This is gonna get it goin' but I'll say it anyway. Coopers are made in America.

Paul
 
mtruckstuff said:
This is gonna get it goin' but I'll say it anyway. Coopers are made in America.

Paul

Our Chervrolet Impala was made in Oshawa, Ontario, Canada.

Our Dodge Ram was made in Saltillo, Mexico.

Our Nissan Maxima was made in Smyrna, Georgia, USA.

Jeep was half owned by Renault when they built my Scrambler.

Which ones are American again? :confused:

This is all so confusing...
 
Boomer said:
I'm giving the Toyo Open Country MTs a shot on my 1997 Dodge Ram 2500. They and the Hankook Dynapro MT RT103 were the only tires I could find with Load Range E, 10 ply rating in 315/75/16 size.

Just in case anyone missed that part... :rolleyes:
 
Pro Comps are made by cooper, as are many off brands.

Carl
 
Boomer,
I'll insert my comments in the text of your message........

Boomer said:
Our Chervrolet Impala was made in Oshawa, Ontario, Canada.

In addition to your Impala, Oshawa (Home of GM Canada) also builds the Buick Allure, Buick Lacrosse, Chevrolet Monte Carlo, and Pontiac Grand Prix, and will produce the 2008 Camaro. ALL U.S. manufacturers have built vehicles for the Canadian market virtually since they began. Early on, they built vehicles specifically for Canada which were not exported south. 100% of profits come home to America. You got this one right!

Our Dodge Ram was made in Saltillo, Mexico.

US, European, Japanese, Mexican parts. Daimler/Chrysler is a German company, anyway, so what's your point? Profits go in several directions depending upon parts vendor

Our Nissan Maxima was made in Smyrna, Georgia, USA.

Also Exterra and Frontier, 100% of profits go to Japan. Why would you want that? I personally wouldn't.

Jeep was half owned by Renault when they built my Scrambler.

Wrong, Renault had 2% interest in AMC in 1982. It wasn't until late 1983 that Renault expanded that to 49% and not 50%. Further, the 1983 Renault Alliance/Encore was the first product the French had a hand in, and they never had influence on the Jeep CJ line right to it's end in 1986. I worked in Product Development for AMC from 1984 to 1987.

Which ones are American again? :confused:

Cooper Tire, which is the subject of this thread, by the way. And GM

This is all so confusing...

It does appear that you are confused.

If you're confused, you should seek clarity.

Anyhow, what's your point concerning the auto industry? We're talking tires here. Seems to me that IF you had the opportunity to "Buy American" and it was a quality product, you'd be interested. Or you simply believe that everything made in the USA is junk, right?

or perhaps you're just trolling.:confused:

Paul (not confused at all)
 
Last edited:
I am also a little curious as to why you don't care where to jobs go or how much they pay as long as the net profits come here, even if they are not likely to be disseminated much if at all. Personally, I feel better about our Nissan being built here by Americans than our Chevrolet or Dodge being built in other countries even if the all of net profits do come here. No one is stopping you from buying stock in foreign companies.

If I could have found a Cooper or Goodyear tire that met my requirements, received favorable reviews, and I thought was a quality or even comparable product, I would have given serious consideration to them. Why so few companies produce E rated 315/75R16 tires is beyond me. But I would not ever feel some incessant need to spout off "Buy American", beat my chest, and berate anyone who disagreed with me every time a foreign sounding name was mentioned.

Let's not forget that Michelin is a French company (although I really like the HydroEdges on our Canadian built Impala), and they own BFG tires, too. So both of those will have to scratched off of Paul's approved list.

Now where did the profits from that 83 CJ-7 and 84 CJ-8 go again?
 
Boomer,
Re-read my posts and you'll see that I wasn't trolling, just acknowledging that someone might get wound up over my patriotism.

My responses are in BOLD type (I'm NOT yelling, just so you know)

Boomer said:
I am also a little curious as to why you don't care where to jobs go (5300 jobs at Nissan in GA, not all of them Americans)or how much they pay (not as much as you might think) as long as the net profits come here, even if they are not likely to be disseminated much if at all.(You don't understand economics, Do a little reading on how Japan and China manipulated the International Monetary Fund regulations. I can only think you resent American companies actually making money) Personally, I feel better about our Nissan being built here by Americans than our Chevrolet or Dodge being built in other countries even if the all of net profits do come here.(kind of convoluted logic:confused: ) No one is stopping you from buying stock in foreign companies.(Who says I haven't?)

If I could have found a Cooper or Goodyear tire that met my requirements, received favorable reviews, and I thought was a quality or even comparable product, I would have given serious consideration to them. Why so few companies produce E rated 315/75R16 tires is beyond me. (You've obviously never looked at Cooper, www.coopertire.com, they have a full range of tires, including "E" rated tires of all sizes.) But I would not ever feel some incessant need to spout off "Buy American", beat my chest, and berate anyone who disagreed with me every time a foreign sounding name was mentioned. (I NEVER berated anyone, not even you, nor beat my chest, although I will now..I'M PROUD TO BE AN AMERICAN!!!! How about you?)
Let's not forget that Michelin is a French company (although I really like the HydroEdges on our Canadian built Impala), and they own BFG tires, too. So both of those will have to scratched off of Paul's approved list.(Michelins generally have harder rubber compounds, while this is great for tire life, it's not so great for traction. BFG's wear horribly and cup badly. I run what works. Fortunately, as I stated in the original post that uspet you so much, Coopers are American-Made. Soooo...what's wrong with that?)

Now where did the profits from that 83 CJ-7 and 84 CJ-8 go again? (51% of it stayed right here(All of it when I bought them), which is a LOT more than hung around after you bought your Nissan. I do the right thing every time I possibly can. Sometimes you just can't. TV's for example. None are made in the US. I like to watch some TV, so I suck it up.)

You seem a little agitated:confused: and definitely insulting:mad: toward me, so I'll pass on the fencing match you seem so intent on having. I'll simply defend myself and be done with it. Sorry you're having such a bad day:(

Paul
 
You really need to learn how to use the quotation feature. I'll try to make sense of that babble when I have the time later on tonight and get back to you in the morning.
 
Back
Top