• Notice for iPhone users: DO NOT use the image size reduction option when uploading photos to the forum. This causes portrait images to post as landscape. We have added a warning to the image insert pop-up as well.

Odometer cable into transfer case help

Scramblin_Jim

Legacy Registered User
City
Goodyear
State
AZ
My speedometer use to work. Just stopped the other day. I had just recently put on the Howell TBI kit and with the kit comes a speed sensor that attaches between the odometer cable and the fitting on the transfer case. I removed the assembly which has the red colored gear that the shape of a skinny pine cone with cross cut teeth. I reassembled the cable, speed sensor (goes inline between speedo cable and housing), and with the red gear and its assembly all out of the transfer case. I can rotate the red gear and see the speedometer needle move. Looks to me everything is connected and working from the red gear to the speedometer head.

I left it all assembled in one piece and slid the red gear back into the transfer case. I expected some resistance putting it in and it was a nice snug fit sliding into place. Tighten it all down and road tested.

STILL DOES NOT WORK!!! :mad: :mad: :mad:

So what am I doning wrong? What have I failed to do, or observe, or did wrong?

I am now suspecting the red gear is not meshing with the other gear inside the transfer case.

Any suggestion on what to try? Thanks in advance.
 
jhpribbeno said:
I am now suspecting the red gear is not meshing with the other gear inside the transfer case.

Any suggestion on what to try? Thanks in advance.
It probably isn't meshing. Once you insert the gear, you have to rotate that assembly into place for it to mesh. There are marks on the outter surface of that assembly that line up with a mark on the transfer case. It depends on the number of teeth on your red gear as to which mark you line up. Too tight will damage the gear. Sort of like setting up a small ring gear and pinion, just not nearly as precise. So, jest loosen the small bolt an rotate it into place...easy.
 
jhpribbeno said:
So where do I find this information on teeth -vs- line up mark?
I "think" it's marked on the housing.
 
I had the same thing happen after installing the Howell system. The rotating cable into the speedometer had pulled back just a tiny bit so as to not mesh inside even though the cable retaining ring was tight. Undo the cable off the back of the speedometer, pull the rotating cable out about a 1/4" and reinstall. That fixed mine. Good Luck
 
Problem solved! The housing that holds the speedo gear is not in the center so as you put it into the transfer case by design, ya got to have the bigger part up toward the top. As you rotate it in it then engages with the driven gear inside the transfer case. When I had installed it previously, I did not pay attention to this relationship and just stuck it in. In that orientation, the speedo gear and driven gear where not messing and therefore no speedo function.
 
John N said:
It probably isn't meshing. Once you insert the gear, you have to rotate that assembly into place for it to mesh. There are marks on the outter surface of that assembly that line up with a mark on the transfer case. It depends on the number of teeth on your red gear as to which mark you line up. Too tight will damage the gear. Sort of like setting up a small ring gear and pinion, just not nearly as precise. So, jest loosen the small bolt an rotate it into place...easy.
Uh-huh.....
 
Back
Top