• Notice for iPhone users: DO NOT use the image size reduction option when uploading photos to the forum. This causes portrait images to post as landscape. We have added a warning to the image insert pop-up as well.

Steering colum question

Copper Pot

Legacy Registered User
City
Denver
State
CO
Having a steering colume question guys.... Jeep can be started without key:eek: , turn signal lever loose and too much play. Needs a new lever spring.

Would it be worth it to install a rebuilt one $300? which I think I am capable of installing, or pay for the man hours to do a partial re-build?

Does anyone know a shop cost on this?

Any feedback would be great! THanks!
 
I went the new/rebuilt route when I had this issue. I had to return my existing column to the rebuilder.

It's not too hard to rebuild if have patience.
 
Replacing the turn signal switch and the ignition cylinder are not that hard. There are two specialized tool needed, a lockplate depressor and a steering wheel puller, but most parts stores sell them cheap. Once the steering wheel and lock plate are off, the turn signal switch comes out with 3 screws, and the ignition cylinder takes either a screw or depressing a tab. The hardest part is threading the turn signal switch wiring back down the column. I just rebuilt a tilt column for a guy- $50.00 plus parts. Took me all of an hour.

As long as you don't have to get into the tilt mechanism, it's pretty easy.

Here's a link with some general instructions/pictures...

http://www.carcraft.com/howto/56459/index.html
 
Last edited:
If the tilt is loose, it is 3-small torx that need to be snugged up. best to pull each one and lock-tight them.
 
....And the parts will cost you about 40 bucks +/-. Just do it yourself. The only way your gonna learn is to do it yourself. And the tools that are needed should cost a total of $25.00. Check the large chain stores, as they may loan out the steering wheel puller, and then it won't cost you anything.:)
 
I noticed that you didn't say wether you had a tilt column or not. I purchased a rebuilt GM tilt column that fit a Scrambler on eBay on the cheap side and installed it myself. By the way, my '82 and many other Scramblers use GM columns. The column came complete, including a new lock cylinder. I personally wouldn't rebuild a non tilt column, but if your needs include a sturdy column for offroad and your size permits, there's no need for a tilt column.
 
Back
Top