• Notice for iPhone users: DO NOT use the image size reduction option when uploading photos to the forum. This causes portrait images to post as landscape. We have added a warning to the image insert pop-up as well.

Welding HDPE fuel tank

Kansas

Basic User
City
Lawrence
State
KS
I'm working on a fuel tank leak in my 1982 Scrambler. It has the 20 - 21 gallon (opinions differ) HDPE tank. No OEM replacement is available. The skid plate was dented by a previous owner but has only recently, 15 years later, developed a leak. Many folks recommend epoxy, but so far as I can tell no epoxy manufacturer claims that it's product with bond to Polyethylene. Most of their websites say they won't bond to HDPE. The leak, of course, is at the bend of one of the right angle corners, further complicating an epoxy repair. There are a number of YouTube videos showing how to weld HDPE and I think it is a legitimate process that would probably work for me. The welding consists of using a soldering iron to liquify the plastic at the leak site and then welding with another HDPE source like strips from a milk jug or oil bottle. Has anyone had experience with this? A major concern is a gas fumes explosion. This seems unlikely to me since there would be no open flames, but from what I can find out the temperature of even a 25 watt soldering iron exceeds the ignition temperature of gasoline. Bottom line is I want a permanent fix so I can avoid dropping the tank and skid plates again, but don't want to kill myself.

I will of course drain and rinse the tank no matter what. I've also read that dry ice will displace gas fumes, which sounds like a simple way to be on the safe side. Another interesting idea recommended on a farm tractor forum is to rinse the tank with diesel fuel.

Thanks for your thoughts - Bill
 
Kansas,

I recommend using the dry ice method if it is available. I used to work for a convenience store chain and when we would need to change out the underground storage tanks, they were always cleaned out and had dry ice put in them to further dissipate any gasoline fumes.

Also, you will want to find some actual HDPE filler material. I don't think milk jugs or oil bottles will be sufficient. There are HDPE products available at the home centers that should be sufficient to use.

All in one idiot's opinion of course.
 
I did some welding on mine. I used an HDPE rod I bought at Mcmaster for filler.

For prep, I dropped the tank and drained it. Put some rinsed gravel and Simple Green in it for a slosh (until soap came through the crack) and rinse. Then let it sit with all hoses off, valves out and sender removed. After a couple days in summer heat it all dried out and you couldn't tell it ever had gas in it.

Some advice on technique - taper the edges of your repair in terms of depth. The transition line between original material and what you add will be the weak spot, so spreading it out makes it more resilient.

After welding and cooling I filled it with water and gave it a few shots with the rubber hammer to see if it would re-crack or leak.
 
Thanks for the advice. I really appreciate it. Any one else is encouraged to chime in.
 
I have an actual plastic welder kit that I've had for about 10yrs. Been used on just about every type of plastic made. I would highly recommend getting some scraps of plastic and practice before you try on the tank itself, especially if you use a soldering iron, as there isn't much control over the temp of the iron. Prep is key, needs to be pretty clean from oils and such and as cbford said taper the edges of the crack then fill in, iit'll be much stronger than trying to just filling the crack in.
 
Back
Top