• Notice for iPhone users: DO NOT use the image size reduction option when uploading photos to the forum. This causes portrait images to post as landscape. We have added a warning to the image insert pop-up as well.

What to do with current paint job

OGRES

Ramblin' Wreck
BENEFACTOR
Lifetime Member
City
Suwanee
State
GA
So my Scrambler is no beauty queen. It had a bad repaint at some point before I bought it of some unknown color. It is rusty and I have a ton of scrapes and gouges in the hood. I also have a large primer grey area on the passenger side that is a bit of an eye sore.

I have considered adding some sort of vinyl striping or wrap to cover the bad spot, but I am now quite sure how that would look. I know there are some fans of Plasti-Dip spray that can be applied and then removed fairly easily at some point.

I don't want to do a bunch of body work and get the whole thing repainted. I also don't want it to look as bad as it does right now. What kind of fairly cheap and/or fairly easy options do I have to make it look somewhat better? What can I do to at the very least to cover up my primer spot?

Picture for reference...

20201129_102445.jpg

20181110_175203.jpg
 
See if an auto paint store could match the paint and mix you up a spray can to paint the primered area?
That is definitely an option. I am worried about being able to match the existing faded paint though. A close color match might be better than what I have though.
 
Find a paint shop with one of those scanners which makes custom paint. Have them scan it right near that primered spot, but not so close that they get primer overspray. I bet you'll be shocked how close a match it is, fade and all.

Then once it's cured, wet sand it with up to 2000 grit around the entire area and then buff it with simonize. It'll be a perfect 10: perfect from 10 feet.
 
I love that plan and it shouldn’t cost you all that much over some of the other options.
 
You could always do a full wrap if you don't want to paint it. It is still quite a bit of work if you DIY. It does help protect the underlying paint from scrapes and scratches. I have several friends that have done full wraps with good success. The hardest part on a CJ to wrap is the hood, followed closely by the windshield frame.

If you don't want to do a ton of work, do as suggested above and spray color matched paint over the primer. Anything more (paint wise) spirals to full rust repair and a complete paint job...
 
Find a paint shop with one of those scanners which makes custom paint. Have them scan it right near that primered spot, but not so close that they get primer overspray. I bet you'll be shocked how close a match it is, fade and all.

Then once it's cured, wet sand it with up to 2000 grit around the entire area and then buff it with simonize. It'll be a perfect 10: perfect from 10 feet.

That is something I will need to look in to. This would definitely be the best method to covering the existing spot and any others I plan to make...
 
Sanding and painting around the primer is very hard to do, even for experienced painters. Their is steps to try to blend it in without having a line between the old and the new paint. Also painting over the primer will take more coats than the blue paint which will make the blend even harder. I don't know your experience on painting but most painters tell you to go from a body line to body line (ex. the pass side of the jeep,, from where tub meets fender to rear seam by tail gate. If you can get the paint to do that section, a slight difference in color isn't as visible. If it's a metallic, or pearl it's almost impossible. Even white was hard to do. Found it easier to fix my mistake (about same spot as your primer) to shoot the section I mentioned. Talk to a paint shop and see how much paint is needed to do the panel, not perfect but better than trying a blend and sand. Perfect jeep to try it on and learn from it. If you have a air compressor, a cheap harbor freight gun could make it interesting. Don't laugh, I've done a fair job with one of those guns (had to start somewhere).
 
Back
Top