• Notice for iPhone users: DO NOT use the image size reduction option when uploading photos to the forum. This causes portrait images to post as landscape. We have added a warning to the image insert pop-up as well.

Why.?.

jeepdreamer

Scrambler Junkie
Lifetime Member
City
Colorado Springs
State
CO
Just curious if anyone has encountered this before...When I pulled the tranny and parts out of the 8 I found someone had used Blue RTV on the bell housing and the metal inspection plate. WHY?
The only thought I had was maybe it rattled or something...but who silicons a bell housing on!?!
:shrug::banghead::shrug:
 
I think blue rtv adds 15-20 horsepower when applied to the bell housing :rolleyes:
 
I think blue rtv adds 15-20 horsepower when applied to the bell housing

YEAH! That must be it! I suspect as you say it was rattling or maybe there was a leak. The other possibility is whoever did it did not realize it is SUPPOSED to be able to come off for (get ready....) INSPECTION! :rotfl:
 
Faster leaks...

Lol! Great stuff guys! After spending the last few hours scrubbing the nasty off the T-case I hope tomorrow will be a little easier. I really can't say what the thought was with the silicon. Its on the bell housing, the inspection cover, And the bigger metal part that has the starter hole. It can't be from trying to stop leaks as it was done whenever the last clutch/tranny install was done. Maybe even when the engine was swapped in? There isn't anything leaking there and the only things that could would be the freeze plugs. And the rattling thing doesn't really make sense since the bell would pull up as soon as the bolts were tightened? The inspection cover maybe but the entire assembly? Bah!
All I know is it has been less than fun scraping it off. Tomorrow is drag it all to the car wash and see if the pressure can help clean some of the nooks and crannies. Not to mention save some elbow grease! :)
 
*shrugs*

Jim.. I honestly have no idea? What makes it stranger is I believe, according to the stack of records that came with the Jeep, that the install was done by a very quality shop! Everything about the V8 swap was/is super factory looking down to the emmissions. The exhaust was well routed and nothing seems even slightly "hacked"...except for maybe some of my stuff.?. *blush*
I'm going to put a straight edge on it tomorrow just to see if maybe the bell is tweaked or something. I can't imagine any shop thinking that sealing the bell would keep water out... in maybe, but out? Nah! I'm really stumped on this one and I've seen a LOT of hacked and shade tree fixes in my 26 +/- years of loving jeeps...?
 
I have seen this done before on vehicles that were going to be driven in deep water.

It is one of those things where if you are rebuilding and think you may want to swamp run at some point, you go ahead and do it so you dont have to take it apart and do it later. it doesnt hurt function for it to be on there, so no real cost invovled. Until you want to inspect and then it may cost some swear words.
 
When I was "Mud Racin" 30 years ago. We sealed everything. Especually the clutch area. Muck n Mud could put you out of a race fast.
 
Back
Top