• Notice for iPhone users: DO NOT use the image size reduction option when uploading photos to the forum. This causes portrait images to post as landscape. We have added a warning to the image insert pop-up as well.

covering the cowl air inlet

ilovetrains

slightly backward
City
Lee's Summit
State
MO
on my build I am ditching the OEM airbox etc in favor of a hotrod style airbox that will not use the factory air inlet.

Has anyone ever seen a pre-made air inlet delete? I hate to result to welding in sheet metal if there is a pre-fabricated option.
 
sounds good, idea on price?
I actually toyed with the idea of trying to fab up an external gauge mount...
 
I'm in the same boat, only I'm going to modify the underdash air box (make it a lot flatter, relocate the drain) so I can still have a source of fresh air.
 
I need to cover mine too. I was just going to cut a piece of sheet metal and sandwich that under a stock cover, but let me know if you make some up Scott, and how much they would cost.

I am going with a this Heater Craft heater (28,000 btu!)

http://www.4wd.com/productdetails.aspx?partID=4691

I bought it on sale and maybe even got free shipping!:smokin: It is made for boats, also, so it should hold up fine to bouncing around in the jeep.

The provided mounts are not as heavy-duty as I would have liked, nor will they really place it in the jeep properly, so I built a mounting tray for it that will defintely hold it solid! I'll post pics later...
 
it depends on the thickness and the material...my buddy with the waterjet can cut any material from plastic to granite...16 gauge steel would be fairly cheap...stainless or aluminum would be higher..let me know what material you guys are thinking...use your imagination..
 
On the topic of that heater, has anyone used one of these and set it up with the stock controls?
 
I used the Heater Craft heater in a Yamaha Rhino. I removed the two single outlets and replaced them with two double outlets I got from an aftermarket vendor. Sorry, I do not remember just who. They just snap out and the new ones snapped in. I then positioned them where I needed them and sealed with silicone. I then was able to run to two heater vents and to two defroster vents. They work great. Came with a three speed switch.
 
it depends on the thickness and the material...my buddy with the waterjet can cut any material from plastic to granite...16 gauge steel would be fairly cheap...stainless or aluminum would be higher..let me know what material you guys are thinking...use your imagination..

any word on getting one cut?
thanks
 
Back
Top