• Notice for iPhone users: DO NOT use the image size reduction option when uploading photos to the forum. This causes portrait images to post as landscape. We have added a warning to the image insert pop-up as well.

100 day summer rebuild

Do any of the aftermarket tubs have the Jeep stamped into the sides?


Dain
 
I MAY HAVE BENT A SHIFTING FORK

it shifts into reverse and 1st ok but it doesn't seem to wan a go into 2nd or 3rd…
it might be that it just needs to roll a little bit, or it may be something else????

That looks like a t176. If you removed the shifter at anytime during the process it may not be installed properly. If so the shifter pops out of the top plate by pulling back the rubber boot, depressing the collar and turning. Then make sure the end of the shifter is properly installed in the detent between the shift rods in the top plate.
 
He may not have time to complete his build simply due the the reading of that thread.


Dain
 
Days 51-53:

the doors windshield hood roll bar fenders grill and tail gate are at the sandblaster…

my welder still hasn't come in... i think it's because of the 4th of july

other then that, i have been sanding the old bondo off the tub… i have a straight edge were i have been checking the how true the tub is and it all looks good except for the passage windshield hinge area…

still having trouble getting that hinge off

ill have more pictures when there is some more progress
 
Or a t150-3speed and Dana 20

What you show there is the back of a Dana 20 transfer case, so Jim is right. It was used up through 1979.

If you do take it apart, get ready with the catch pan. The gears are exposed on this design right from the start when your separate the t case from the trans.
 
Day 54:

Did a ton of sanding and body work today!!!

Finally got the the windshield hinge off…. a lot of rust!!!

bondo….

IMG_1710_zps62fe5079.jpg
[/URL][/IMG]

IMG_1711_zpse719327c.jpg
[/URL][/IMG]
 
days 55-56:

more bondo, the welder came and i took a 3 day welding class for intro mig welders… I'm more confident and have had some practice

body work and paint should be done by the end of next week

IMG_1717_zpsa540df4a.jpg
[/URL][/IMG]

IMG_1716_zps60a2ba96.jpg
[/URL][/IMG]
 
Good morning Elliot, that looks nasty.
If you need an "A" pillar / windshield corner let me know and I'll cut one off for you. I have a couple sitting here now. :wave:
 
Day 57:

Here is what i did…

1/8" steel and some reinforcements

IMG_1717_zps2503b43b.jpg
[/URL][/IMG]

IMG_1718_zps7234f33a.jpg
[/URL][/IMG]

IMG_1719_zps58a8d1d6.jpg
[/URL][/IMG]

IMG_1720_zps4102e519.jpg
[/URL][/IMG]

IMG_1721_zpsfb793b2a.jpg
[/URL][/IMG]

IMG_1722_zpsa50aef96.jpg
[/URL][/IMG]
IMG_1724_zps52e95e2d.jpg
[/URL][/IMG]
 
Nice job! :thumbsup:

That looks like it will work. You are a quick learner. Keep up the good work. :wave:
 
Back
Top