Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Notice for iPhone users: DO NOT use the image size reduction option when uploading photos to the forum. This causes portrait images to post as landscape. We have added a warning to the image insert pop-up as well.
My plan is to fab a new box or try to mod the one that came in the kit. I want to run 2 ducts from the factory square holes to the box. There shoupd be enough air from them. Right now i just want to get it running then iron out the details.
This is my fan from a Ford 500 that I got for $30 at a pick yard. It is a dual fan and dual speed. I set it up for low speed on the large fan and high speed on the small. If I have cooling issues I will just change the wire on fan to get more CFM.
I am working on my setup right now. I bought a cheep $60 kit for a Chevy Silverado and then bought a K&N filter for it. This is much less money than spending $300+ on the U built it kits.
I used the same bolt locations as the drum backing plate with grade 8 and locknuts. I cut the backing plate down to be a small ring so I can still use it as a bearing/shaft retainer.
I have on under my CJ8 that I built about 5 years ago. I like it alot. The housing is very heavy the tubes are thick. I converted to my own built disk brakes, went with a Detroit Trutrac and added G2 gears. As far as extra width, I have to use 6 inch flares to keep my 33x12.5 wide tires...
Wow, $800 for a Bestop vs $2600 for this brand is a tough pill to swallow. I am sure this is better quality but to be honest I have been running Bestop's my whole Jeep life and never thought they were junk. My CJ-5 Supertop lasted 20 years before I sold the Jeep.
I know Jeeps are not meant for gas mileage but the JL and JT does have better smoothed and more wind friendly lines. With that being said I wonder how much this angled grill affected the MPG at highway speeds?
Its fine really. I appreciate any help. The top one I just bought a speedway motors inline steam port adapter and it goes up in size to fit the radiator so I have that part covered. If you don't find it do not worry, I will just head to Napa and size one up. You got me very close as it is.
So I bought these hoses and the top hose is very small in diameter and the bottom one needs another 12 inches in length. Did you use two different hoses for the bottom one?
I don't blame you one bit on that account. They pedal still might be a bit high for my liking but time will tell. If it is then I will just tilt the whole assembly with spacers from behind the mount. I have a good 2 inches behind the pedal to the floor at full throttle and the swing is...
The shifters for both cases are all setup and functioning. This was a Muther effer of a job to get exactly correct and too far longer than it should have taken. I managed to land them in the same spots as before so my cover and boots will still work and save me a few bucks. Overall I am very...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.