Search results

I don't see anything recent so bear with me. Thoughts on a Powertrax 9201202900 "No-Slip Traction" unit for my current 2 pc amc 20 4.10 setup? This is 99% street driven - but thinking of doing a bit of exploring in the hills. No LSD of any kind front or back - just thinking about adding...

What should the size of the brake line be from the proportioning valve back to the flex hose for the rear axle? I put 3/16 on mine - wondering if that should be 1/4 to match the size of the line from the master cylinder to the proportioning valve?

What's the recommended procedure for jacking the front to remove/replace the Front Shackles? The back of the springs seems a long way aft and there's nowhere obvious to spread across both frames, underneath the cowl mount? Or 3 jacks? not much room for axle stands either though :(

Happen to have some free time with the latest pandemic situation, so here's some catchup. Purchased this in 2017 - probably should have done something different - but... / We started to strip it down immediately, i was in no doubt that the rust bug was everywhere. I hadn't bargained for how...

It took 2 months to resolve this, my woes may help someone else. Background, rebuilt TF999 with lockup torque convertor, partially rebuilt 258. Holley Sniper EFI, stock coil, GM HEI module mounted to stock distributor. The EFI Got the engine running fine, except that i noticed that the engine...

So on my Postal there was never a jack mounted in the engine compartment, but there was provision for the bracket assembly for the jack, including the screws. So i bought a bracket and jack at the York Show a couple years ago, come to fit the jack in the bracket this week, but find that the...

All the local polyurethanes we tried came out with a crummy finish. Anyone tried this stuff? https://www.kbs-coatings.com/DiamondFinish-Clear.html

So my 84 Postal has some kind of inserts in the roll bar where the seat belt mounts should go, except they're not threaded.:unsure: I believe they just need to be tapped 7/16-20 - can anyone confirm? Bolts are another matter - i'll probably use Ferry Cap Screws with some sleeves(to account...

I'm not going to explain why i had to do this :banghead:, just how. Suffice to say i needed to swap out a torque convertor and didn't want to pull the engine or transfer case/skid plate and too cheap to buy a large jack to fit the transmission jack i borrowed. So made my own transmission...

My transfer case (Dana300 was shot (splines worn etc) I ended up with an earlier one with the short output shaft, this is about 1" shorter than the later version. Thoughts on using the stock driveshaft - which is now 1" too short? It is probably at the upper end of the length as installed with...

In the process of adding a tailgate to my Postal, i think i'm missing 2 brackets - #6 on picture Can someone take a couple of pictures, i may have to make them.

Any ideas?, it appeared in the bits to clean and paint group, i think it's off the Postal:oops: It;s steel - about 0.25 thick - Sharpie for reference

Can't see anything recent, so.... Looks like i need a pair of rear quarter panel repair patches for my Postal, which has (too) extensive rot adjacent to the wheelhouse and floor corner panels. Am i correct in thinking that only MD Juan makes these, there seems to be a fair variety of prices though.

So i got an 84 Postal down to the frame - i promise to post some pics at some point, however it's pretty much following the same path as Jeepscramblers 1984 Alaskan Postal Scrambler Build. i need him to finish it - otherwise i''ll get stuck sometime;) Anyhow a here;s the question On a first...