- City
- Dexter
- State
- MI
Since CJOffroad seems permanently dead (so incredibly sad how much awesome swap info died with it
) does anyone out there know about resources/info related to getting the check engine light/MIL working on an OBDII swap?
EVERYTHING I looked at was on that site and as I wasn't concerned with getting it working in my swap immediately due to not having emissions here, I didn't save off anything relative to it. I've come up empty in searching, everything ends up pointing back over to CJO.com
I do believe that I never saw a thread where anyone actually had a working solution, lots of dead end "how do I..." threads or people saying "the way you'd figure it out is..." though. But I wasn't looking hard either, as mentioned.
I'm asking because I have connected with an automotive design engineer that I am working with to develop an all-in-one, easy-to-install digital solution to this for all 4.0L engines from 96-02 that will work without the cluster. We have a prototype and I've been searching to find anything about alternative/competing solutions.
Any info/resources/links would be very appreciated.
Also, if you did the swap or were thinking about the swap and would be interested, let me know.
) does anyone out there know about resources/info related to getting the check engine light/MIL working on an OBDII swap? EVERYTHING I looked at was on that site and as I wasn't concerned with getting it working in my swap immediately due to not having emissions here, I didn't save off anything relative to it. I've come up empty in searching, everything ends up pointing back over to CJO.com
I do believe that I never saw a thread where anyone actually had a working solution, lots of dead end "how do I..." threads or people saying "the way you'd figure it out is..." though. But I wasn't looking hard either, as mentioned.
I'm asking because I have connected with an automotive design engineer that I am working with to develop an all-in-one, easy-to-install digital solution to this for all 4.0L engines from 96-02 that will work without the cluster. We have a prototype and I've been searching to find anything about alternative/competing solutions.
Any info/resources/links would be very appreciated.
Also, if you did the swap or were thinking about the swap and would be interested, let me know.




Someone must have figured this out by now
(or try to convert an OBDII to OBDI, which works, but is not going to be cheap). To my knowledge, the ONLY thing that would prevent a proper OBDII swap from smogging in one of those locations is the lack of a working MIL, so there would seem to be all kind of need for something like we're developing.
Ok, I will