• Notice for iPhone users: DO NOT use the image size reduction option when uploading photos to the forum. This causes portrait images to post as landscape. We have added a warning to the image insert pop-up as well.

Alright...so who's got the last remaining WT Dana 44 rear end squirreled away....

TrebleHook

CJ-8 Member
Member
City
Fairfax
State
VA
Been looking for a WT Dana 44 couple years...apparently so have EVERY SINGLE OTHER CJ OWNER.....

SOMEBODY's got to have one that they'd part with....

Any recommendations if I have to go NEW?

Thoughts?

Cheers,
Dylan
 
there around.. i posted 2 of them on the forum from craigslist last year.. in the spring time the cool parts come out..
 
I had one a few years ago. sold it for $300.
 
I used the last one. !!!!
eratydyp-1.jpg



Sent from my iPhone
 
I gots one squirreled away in the garage to put in the P'ostal. Also have one in or '84 CJ7.

:bacon:
 
I have two stowed away, one for my Scrambler and one for my brother's. Both are the only ones I have found locally in the past 7 years. :shrug:
 
Mine came in this. 86
adurudu2-1.jpg

Only one that I've had in. 9yrs and. 40+ jeeps



Sent from my iPhone
 
I believe the Scout Dana 44 is just a little wider then the 86 CJ Dana 44. I bought what was supposed to be a CJ Dana 44, but it is a little wider then my front widetrack dana 30. I think I actually have a Scout Dana 44 under mine. They are a lot easier to find.
 
The Dana 60 I have is 57 inches wide
It's very hard to tell that it's wider than the front, but the fact that I know it will drive me crazy


Sent from my iPhone
 
I would go with a Scout or Isuzu Dana 44. Both area little wider but if go the shortened Waggy 44 in the front then you are right on target.

There are a few little issues with any of these. But it is easier to find shafts for the Scout and Isuzu rear ends.


Carl
 
The Dana 60 I have is 57 inches wide
It's very hard to tell that it's wider than the front, but the fact that I know it will drive me crazy


Sent from my iPhone

I hear your selling that dana 60 to me in the future. .. take care of it in the mean time. .. :)

Sent from my SPH-L900
 
I've always sided with the stock AMC-20 rear axle with an aftermarket one-piece modification as being a stronger axle than a Dana-44, but opinions seem to vary about 50-50 on this preference. If I was looking for more strength in an axle over the AMC-20, I'd simply go Dana-60 and forget it.
 
I have one I'd consider selling. 3.73 and Detroit. The problem is that A) it has a busted left-side shaft, and B) it's in Alaska.
 
Found it!

Well...it's who you know!

Friend of a friend of a CJ parts guy puts me onto a professionally rebuild 86 CJ Dana 44 rear...with receipts...sand blasted and painted...drum to drum...in 3.31...installed in a nut-n-bolt restoration project....never driven...4 hours away...for less than the receipts on the rebuild.

I can bolt it under my Scrambler when I install the 4" BDS lift w/ Fox shocks I pick up on Wednesday!

Eventually it'll go 4.10s with a locker...but beggars can't be choosers!!

Oh...my...my....mine!

Cheers,
Dylan
 
Back
Top