• Notice for iPhone users: DO NOT use the image size reduction option when uploading photos to the forum. This causes portrait images to post as landscape. We have added a warning to the image insert pop-up as well.

Body mount capture nut options?

RichandPoor

New member
City
Suffolk
State
VA
All but 2 of my body mount bolts sheared off when I removed the tub. Most were corroded down to an 1/8" of diameter. What are my options as it looks like I will have to cut the body in those sections to replace it, then weld it back up?

Could cut and tap my own plates or cut/drill plates and weld a nut on the backside

eBay option:
I messaged the seller to ask what kind of metal they are using, zinc vs galvanized vs bare steel but no response

Have seen Classic Enterprise option but it isn't listed on the website. May call and ask since I need to order a few panels anyway.
 
Pretty sure most of these will just be 0.25" (maybe 5/16") Hot Roll steel plate with a 3/8 UNC threaded hole. Paint them before spot welding the cage, and you should be OK. Classic don't usually apply any coating.
 
I reused the flat stock. Cut into the crib to release the plate. Torch the sheared bolt to a glow. Quench in cool water. Busted frozen bolt will almost come out by hand. Clean, paint, chase the threads, rebuild the pocket install new bolt.
 
I used a thick flat steel bar from Home Depot. Cut, drilled, and tapped threads. Then I made a cage with sheet metal so the nut would not spin and welded into place.
 
I heated and fought the two that fell out and no luck. 20 years abandoned sitting 100' from the beach seems to weld a lot of stuff together.

Definitely 5/16" so I will make my own from steel stock. Thank you for the help!!
 
Back
Top