• Notice for iPhone users: DO NOT use the image size reduction option when uploading photos to the forum. This causes portrait images to post as landscape. We have added a warning to the image insert pop-up as well.

CJ 7 roll bar in a CJ 8

05unlimited

Legacy Registered User
City
Lancaster
State
CA
Will a CJ 7 main hoop (with the legs removed) bolt into a CJ 8 (with the bolted in braces where the "7" hoop bolts to the tub removed). I want to use a "7" main hoop for a full cage I am planning for my "8". Thanks in advance fo any answers to this question.
 
not sure I'm following you, are you are talking just the main hoop of the 7 bar down behind the seats of the 8? The 8's bar bolts to the bed behind the bulkhead whereas I believe the 7 bolts to the floor behind the seat 4-6" lower than the bed deck so you may have to shorten the hoop and reattach the feet to attach to the 8's mounting location in the bed. Unless I am totally misunderstanding. Width wise though the 7 bar should fit between the tub sides
 
The "8" has a bracket installed where the "7"'s roll bar would mount. I was asking if I unbolted the 8's brackets and cut off the rear legs of the 7's roll bar, would the 7's main hoop floor mounting plates bolt directly to where the 8's floor to riser brackets were.
 
It looks like the 7 main hoop will in fact bolt in. I've been looking at doing the same thing. The brackets on my 84 are bolted to the floor with the normal Torx bolts, but appear to be riveted to the raiswd upper floor section. hope these come of easy!
 
It looks like the 7 main hoop will in fact bolt in. I've been looking at doing the same thing. The brackets on my 84 are bolted to the floor with the normal Torx bolts, but appear to be riveted to the raiswd upper floor section. hope these come of easy!

The brackets un-bolt. There are no rivets.....just Torx.
 
I think it will hit the stock sport bar. For sure it will not fit inside a half cab, both due to the angle of the bar. My cage uses a YJ main hoop, but it was cut and rewelded to be vertical. But the feet will fit a Scrambler after removing the bracket as mentioned.
 
Back
Top