Good evening a continuation of the 20's rebuild. Hung the AMC 20 under the frame and started on separating the hubs from the axle shafts to change out the bearings. Took a little work to get the nuts off. My little 1/2"Milwaukee didn't cut it and I tried brace and heavy hammer to no avail.
View attachment 89070 So in the end I called my son to borrow his big Milwaukee. That made him happy...I wonder why? Maybe I'll return it.
Used an older model OTC hub puller. It worked great. Left the nut on, torqued the puller and a couple of hammer hits and pop.
View attachment 89069 View attachment 89060
Pressed off the bearings and waited for new one's to shortly arrive. Packed them and installed on the axle shafts.
View attachment 89062
View attachment 89063
View attachment 89064 This one is ready to go in.
View attachment 89065 View attachment 89066 Never did an AMC before and didn't find any reference as to how much grease these bearings require. Both sets of axles I have had next to none and the bearings, seals, dust cover showed the wobble. So I treated it like a trailer axle. A lot. Kept it off the inner seal but filled that void between the seal and race.
View attachment 89067 Left side installed. Right side already done.
View attachment 89068 My jig to install the hub. Let you know how that works. If not, read somewhere that I can press the hub on as a complete assembly, taking measurements to determine the proper hub to axle end distance, and then torque the nut. I like the idea but don't want to install the whole assembly. Would rather get the backing plate bolted on, check axle tolerance with the existing set of shims, install the drum brake components, and then install the hub. That is the plan for now subject to change. You and yours..be well.