• Notice for iPhone users: DO NOT use the image size reduction option when uploading photos to the forum. This causes portrait images to post as landscape. We have added a warning to the image insert pop-up as well.

Deez Captured Nutz

Emile

Active member
City
Wilsonville
State
OR
It was going so swell until it wasnt. I got all the body mount nuts off except for this one on the driver side behind the rear wheel. It's spinning .... so time to go inside. I'm thinking of cutting a little access hole right below and to the left the existing hole with all the foam in it. Anyone else have any better ideas?
 

Attachments

  • 20220418_144548.jpg
    20220418_144548.jpg
    162.2 KB · Views: 16
I had the same problem,I drilled 1/8 or similar size small hole in-line with nut and screwed self taping screw in hole ,the captured nut would hit the screw and not turn.
Pull screw your left with only a small hole.
 
Did the foam out and insert a wrench to hold nut. If a wrench wont fit stick a old screw driver/pry bar in there to keep the nut from spinning.

I would also heat that bolt head up with a torch until it is glowing red.
 
Jump back 30 years- I had the same issue, I cut a big hole to get my wrench in(looks like crap. don't do that). this time I had the same on the passage side. I cut the head off the bolt and punched it up through.
 
The first thing to do is dig all that foam out. From there and any other place you can find it. That stuff will soak up water and start the rust process full speed. I’m thinking that’s why the nut is spinning.
Once the foam’s out, maybe some penetrating oil on the nut will be beneficial. You’re going to have to find a way to hold that big square by stationary. You may end up cutting the bolt off and punching the whole assembly up and out. Then either thread a plate or weld a nut to a drilled plate, drip the plate back down in the channel and install a new bolt.
 
Ended up punching it up and removing the foam, pretty simple process. Also had to cut open the rear crossmember to access that one but that should be a pretty easy patch job to fix. What's amazing is that the whole body is level now where it was sagging almost 3/4 of an inch beforehand.
 
Back
Top