• Notice for iPhone users: DO NOT use the image size reduction option when uploading photos to the forum. This causes portrait images to post as landscape. We have added a warning to the image insert pop-up as well.

Differences between CJ8 and CJ7 rollbar?

RichandPoor

New member
City
Suffolk
State
VA
Pretty sure they are very different and you can't use a CJ7 on a CJ8 without a lot of cutting and welding to put in the additional sections required on the back legs which was my original plan but I found a CJ8 rollbar while on travel. Trying to figure out what my time is worth and I forgot to measure while it was in front of me.
 
Big differences, Tube diameter is different. How they mount in the rear is different. How they mount in the front is different.

The Overlanders had a few versions, mine has a -7 / -8 hybrid. Diameter matches a -7, front mounting matches a -7, rear mounting matches a -8. With this roll bar you cannot install a bulkhead and half cab. That is the main problem using a -7 cage as a starting point.
 
If you want an original, I think that Dustin, JeeperDD on here, has one near Zion Crossroads, west of Richmond.
 
Thank you all for the help and pictures! I way underestimated the differences so this is really really helpful. I don't have a cj8 hardtop but do have a hardtop from a different jeep, maybe a CJ7 that I plan to use. Any idea if a non-CJ8 rollbar would be better?
 
Not better, not worse. These are NOT roll bars. They are “sport” bars. There is not enough body to frame supports to give them the strength needed in a roll over accident. The weak point for all of these bars is the bar to body mounts. In a roll over accident, the mounts will push through the unsupported floor boards.

As such, use the one that fits your need. If you have a back seat, the cj/yj sport bar has mounting points for the 3 point seat belts.

As you can see, the foot mounting points cross the plane for the bulkhead and mounts on the low portion of the floor. The CJ-8 bar mounts completely in the bed.
 
Here is how the bar in my Overlander mounts.

7F6B412A-9C11-4CED-B5CD-4715EFF2993F.jpeg

The five holes to the left is where a stock -8 bar mounts. The edge of the step in the floor is where a -8 bulkhead mounts.

The -7 bar is smaller diameter and hugs the body more, it might let a reclining seat recline more than a -8 bar would.
 
Here is how the bar in my Overlander mounts.

View attachment 105781

The five holes to the left is where a stock -8 bar mounts. The edge of the step in the floor is where a -8 bulkhead mounts.

The -7 bar is smaller diameter and hugs the body more, it might let a reclining seat recline more than a -8 bar would.
Eh, I went over twice back around 1994-95 in my Tan CJ-7. Roll bar was fine. The hard top, doors, windshield frame, hood, front fenders, and grill were a little dinged up.....did not buff out LOL

Roll bar was fine though. Obviously not as stout as one would be tied into the frame, but they aren't useless either.
 
Back
Top