• Notice for iPhone users: DO NOT use the image size reduction option when uploading photos to the forum. This causes portrait images to post as landscape. We have added a warning to the image insert pop-up as well.

HEI Problem

SLICK_N_STICKY

Basic User
City
LAPORTE
State
TX
I installed a new HEI off e-bay in my Jeep.Everything went great,But engine had a miss when I started it up.Checked a few things out and found I'm not getting fire on #3 and #4 Cyl. Plug wire/Plug check good and checked continuity thru cap and it's good.This is a new one on me?Jeep runs ok,Just not hitting on all 6 cyl.Anyone know what the heck going on?
 
When you say you aren't getting fire to #3 and #4 do you mean:

1. The distributor isn't sending voltage down the #3 and #4 wires to make a spark?

or

2. Cylinders 3 and 4 aren't firing?

Any possibility you've swapped the wires to the 3 and 4 plugs so they aren't firing at the right time?

Jeff
 
jscherb said:
When you say you aren't getting fire to #3 and #4 do you mean:

1. The distributor isn't sending voltage down the #3 and #4 wires to make a spark?

or

2. Cylinders 3 and 4 aren't firing?

Any possibility you've swapped the wires to the 3 and 4 plugs so they aren't firing at the right time?

Jeff

Could be that the wires are running side-by-side to closely and cross firing into each other.

Rob
 
My wires are new I even switched them around thay fire in another place?I never herd the Jeep run before I gutted everything,But everything is new.Does anyone know the part number for new cab/rotor.I might just change the cap and see what happens?This is weard science.
 
Last edited:
Just to let you know when I did my install mine was rough till I did the timing correctly with a cheap timing light.
As they say, timing is everything. If you have done this, then disregard, but if you haven't got the timing down it'll run crappy.
 
HEI upgrade

Looking to do the upgrade my self. Would you recommend a seller on EBAY? What did you do for wires and plugs? How long to ship? I'm putting my engine back together after a complete tear down and rebuild, and I'd like to get the distributor in before I put it back in the jeep. NOT absolutely necessary of course, just my desire.
 
lascrambler said:
Looking to do the upgrade my self. Would you recommend a seller on EBAY? What did you do for wires and plugs? How long to ship? I'm putting my engine back together after a complete tear down and rebuild, and I'd like to get the distributor in before I put it back in the jeep. NOT absolutely necessary of course, just my desire.
Here is where I got mine....These guys know anything and everything about an AMC engine! Will take about a week to get it.
http://www.bulltear.com/catalog/index.php?cPath=21&osCsid=8b88aace232f92aa9885de3b137c6466
They can provide you with wires too!
Get your plugs at the local auto-parts.
 
lascrambler said:
Got it thanks for the info. Do I use stock plugs or upgrade to something else:confused:
You can use stock plugs, but open the gap up to between .045 and .055.
 
Thanks for the help

Well I've got everything installed but am unable to start yet. I need a CTO, or a plug before I can put the coolant in the engine. Hope to have it started up in a day or so.

I read some where that with an HEI upgrade I now have to run high octane fuel. Is that so?
 
No you dont have to use high octane. Others may use it, but thats just a preference.
 
Back
Top