• Notice for iPhone users: DO NOT use the image size reduction option when uploading photos to the forum. This causes portrait images to post as landscape. We have added a warning to the image insert pop-up as well.

Help throw out bearing is to long

O

Osojack

New member
City
Bloomfield
State
Nm
Hi can someone point me in the righ5 direction doing a ls swap Trans is ax15 the throw out bearing is to long 1.43 id is there a shorter one available
 
Moved this to the LS Swap section, I can't help myself, but I believe that throwout bearings for different setups has been discussed before, if you search. @spankrjs paging you to see if you can help him...
 
Ron84cj

Thread 'LS to AX15'

I'm taking much of this info from my build thread. I'll try to clean it up and also add to it as much as possible. I started a pretty nasty rod knock on my 258 back in 2016 right after Sandblast so I needed to make so decisions. I actually had an extra 258 I could have used. It had about 76,000 miles on it. It would have had to be gone through because it was sitting for a VERY long time. I could have gone this route, it would actually make a lot of sense. But I needed more power! :bacon: So this gave me a good excuse to swap in a chevy 5.3L. I will have a good 100 more horsepower and still...

This is Ron's thread, read all the way through it. He did have an issue with the second setup so we will have to wait to hear from him about it.
 
Sorry guys. I just first saw this now. I will update that thread today when I go on break at work. And yes, I did solve my issue.
 
I updated that thread. If you have any additional questions let me know.
 
You must log in or register to reply here.
Back
Top