Ok.. picture worked...
These are available from junkyards anywhere. Or new from Carter, Delphi, AC Delco, Walboro, Airtex, and others.
The one for the mid 2000's GM truck works well because it is the right height for our tanks without modification. The cup sits on bottom of tank on the feet you see in picture and you press down the spring loaded tube legs until the cap sits into hole on top of tank and the lock ring goes on.
So it doesn't need a seat or bracket to sit still, sloshing fuel wont push it around and it doesn't need an external baffle to keep your pump sitting submerged in fuel.
But it does require a 4 inch hole in the top of the tank to mount it. And a flat flange in tank to seal against, and a top sealing ring to press cap of assembly down onto the tank flange.
4 inches is perfect size hole.
Now where to put this thing?
Here is the inside of our tanks. This is the plastic 20 gallon stocker. it has a 3/4 inch deep, slightly sloped sump that is about 8 inches wide at the bottom, center.
You can also see the back (as in rear of vehicle) has an upward slope to it which is why bending up a custom in tank pump on tubes for the stock opening is a pain. It cant go straight down, it has to go left about 2 inches and forward about 1.5 inches to reach flat, deepest part of tank.