JohnnySix
Legacy Registered User
- City
- Arlington
- State
- VA
I'm installing the windshield channel for a bikini top and also installing the wooden side rails. I want to do this right (goes w/o saying) and keep everything looking clean and tight.
My questions are:
1) Is there a special drill bit I should use? And at a certain RPM range?
2) After the holes are drilled, should I paint/treat the newly exposed metal to prevent rust?
3) Any other pointers,tips, tricks, etc.?
Thanks for the help.
My questions are:
1) Is there a special drill bit I should use? And at a certain RPM range?
2) After the holes are drilled, should I paint/treat the newly exposed metal to prevent rust?
3) Any other pointers,tips, tricks, etc.?
Thanks for the help.

