I am in the process of installing the Novak kit on my jeep, using an sm465 transmission. I used a master cylinder from an old YJ 4 banger with manual trans.
The Novak slave cylinder has thread adjustments on the slave tip, as well as mounting slots that you can use to position the slave cylinder forward or backward about an inch, so there is plenty of adjusment at the slave cylinder.
Couple of things to consider:
1.They supplied a bracket and clutch fork, but you have to supply your own throwout bearing (they have a Novak "Guide to Clutches, Linkages, & Bellhousings" to get the spec from). Regarding adjustment, in the instructions it says "if you have chosen the wrong throwout bearing, no amount of adjustment will remedy it."
2. The original cj master has a hard plastic line, whereas the Novak has a threaded hose end. I have a brass compression fitting that I will use to connect the two, once I decide exactly where to cut the plastic line.
3. At least on mine (LT1 motor), the Novak slave hose would have been in conflict with the stock exhaust manifold outlet. I would not have this problem if I had center dump headers. Anyway, I just got a 90 degree fitting to fix that issue.
Maybe it would help if you could provide some more details on your drivetrain and maybe some pics.
I should know by this weekend whether or not my setup will work Keeping my fingers crossed!
-Mike