• Notice for iPhone users: DO NOT use the image size reduction option when uploading photos to the forum. This causes portrait images to post as landscape. We have added a warning to the image insert pop-up as well.

It's all together and running; BUT no oil pressure

lascrambler

lascrambler
City
Pagosa Springs
State
CO
Here's what I've got.

As part of my engine rebuild I installed a new pump. No indication there was anything wrong with the old one, just didn't want to risk having it go bad after all the hard work. Well guess what...:angry:@#$%&!!.

During assembly I did the best I could to run the oil pump using my old distributor minus the cam shaft drive gear. This got oil up to all the valve rockers except the 2 for cylinder 1. I pulled the rockers and the pushrods had oil in the tubes, so I just figure I wasn't turning the pump fast enough.

Now I have every thing together and I have no oil pressure indicated until I rev up the engine. Then it gets up to about 20psi. Checked the gauge per the shop manual and it's okay. Ran a jumper wire direct from the sensor to the gauge and got the same result. Checked continuity on sensor wire between the gauge connection and the sensor conection and it's showing a open circuit, thus the jumper.

Pulled the oil filler cap and I don't see oil coming out to the rocker push rods.:confused:

The only thing I know to do is pull the oil pan and check the pump, but I thought I'd leave a post here just incase someone out there had a better idea.
 
still looking for help

So far I've replaced the oil pump (again), blanked off the pressure relief valve, and checked bearing clearance at the #3 journal. No problems found or resolved.

I'm thinking I must have missed something puting the cam shaft in. Here's why. After I had the engine assembled I ran the oil pump with a drill motor to varify the pump would work. That's when I realized the machine shop had removed a plug (1/4 NPT) on the back of the engine. I had replaced all the freeze plugs and the rear plug for the cam shaft, but I didn't notice this other plug was missing. Anyway, when I tried the pump I dumped about a pint of oil on the floor. Now if there is a similar plug of the front of the engine under the timing chain cover it wouldn't be so obvious.
 
Wish I had my old block sitting out there still to check for you, but it's gone... did you try to google some pictures of a 258 block to see if you can spot it on one of those? Just a thought.
 
I think this is it

My Haynes Manual shows oil channel plugs on the front and back of the engine. I'm pretty sure the front plug is not installed. I haven't torn the thing down yet, will get to that this weekend.

I scanned the image, but I don't know how to get it to show in this post,
 
It's running

I pulled the timing chain cover last night and the plug was missing. I installed a plug, and tested the pump with a drill and got 60psi. Put the thing back together and I have 60psi steady at idle. I'm ready to roll.:D

I've got pictures I'll try to post. This was a painful lesson to learn, but maybe it will help some one else.
 
Last edited:
WildTurkeycj8 said:
So did you risk any damage to your engine from running it like that?

No, mostly I use and old distributor with the gear removed and a drill motor. The short time that I did run the engine was minimal, I use a fair amount of asembly lube, and base on what I saw before installing the valve cover, I got oil to all the rocker except #1 cylinder. So there was some resistance in the system.
 
Back
Top