lascrambler
lascrambler
- City
- Pagosa Springs
- State
- CO
Here's what I've got.
As part of my engine rebuild I installed a new pump. No indication there was anything wrong with the old one, just didn't want to risk having it go bad after all the hard work. Well guess what...
@#$%&!!.
During assembly I did the best I could to run the oil pump using my old distributor minus the cam shaft drive gear. This got oil up to all the valve rockers except the 2 for cylinder 1. I pulled the rockers and the pushrods had oil in the tubes, so I just figure I wasn't turning the pump fast enough.
Now I have every thing together and I have no oil pressure indicated until I rev up the engine. Then it gets up to about 20psi. Checked the gauge per the shop manual and it's okay. Ran a jumper wire direct from the sensor to the gauge and got the same result. Checked continuity on sensor wire between the gauge connection and the sensor conection and it's showing a open circuit, thus the jumper.
Pulled the oil filler cap and I don't see oil coming out to the rocker push rods.
The only thing I know to do is pull the oil pan and check the pump, but I thought I'd leave a post here just incase someone out there had a better idea.
As part of my engine rebuild I installed a new pump. No indication there was anything wrong with the old one, just didn't want to risk having it go bad after all the hard work. Well guess what...
@#$%&!!. During assembly I did the best I could to run the oil pump using my old distributor minus the cam shaft drive gear. This got oil up to all the valve rockers except the 2 for cylinder 1. I pulled the rockers and the pushrods had oil in the tubes, so I just figure I wasn't turning the pump fast enough.
Now I have every thing together and I have no oil pressure indicated until I rev up the engine. Then it gets up to about 20psi. Checked the gauge per the shop manual and it's okay. Ran a jumper wire direct from the sensor to the gauge and got the same result. Checked continuity on sensor wire between the gauge connection and the sensor conection and it's showing a open circuit, thus the jumper.
Pulled the oil filler cap and I don't see oil coming out to the rocker push rods.
The only thing I know to do is pull the oil pan and check the pump, but I thought I'd leave a post here just incase someone out there had a better idea.

