lascrambler
lascrambler
- City
- Pagosa Springs
- State
- CO
So I started a couple of weeks ago cleaning up the cockpit and applying Herculiner to the floor, firewall, and divider wall.


However, when I finished that I thought heck there really isn't that much left to take off the dash so it was on. The dash is out, pedal assembly, steering column, front fenders, divider wall, tailgate, roll bar, etc., etc. I now have the body disconnected from frame and ready to clean up the frame and underside of the body.

View attachment 48955
I posted for some help on the roll bar bolts, and since I didn't have a welder or torch, I drilled and chiseled them off. This was not friendly to the weld nuts, and a few of them broke off. I also let the chisel get away from me a couple of time and it hit the side wall of the bed. Not good. All can be repaired, but still mad at myself. Note to self and others, put a piece of wood behind the bolt..
One part I cannot find are the T-studs for the rocker panel covers. I have three that twisted off when I attempted to remove the nuts. Worse case is I can get them drill and tapped for a ¼-20 and thread in a new stud. But finding new ones would be easier.



However, when I finished that I thought heck there really isn't that much left to take off the dash so it was on. The dash is out, pedal assembly, steering column, front fenders, divider wall, tailgate, roll bar, etc., etc. I now have the body disconnected from frame and ready to clean up the frame and underside of the body.

View attachment 48955
I posted for some help on the roll bar bolts, and since I didn't have a welder or torch, I drilled and chiseled them off. This was not friendly to the weld nuts, and a few of them broke off. I also let the chisel get away from me a couple of time and it hit the side wall of the bed. Not good. All can be repaired, but still mad at myself. Note to self and others, put a piece of wood behind the bolt..
One part I cannot find are the T-studs for the rocker panel covers. I have three that twisted off when I attempted to remove the nuts. Worse case is I can get them drill and tapped for a ¼-20 and thread in a new stud. But finding new ones would be easier.

Last edited:


















