• Notice for iPhone users: DO NOT use the image size reduction option when uploading photos to the forum. This causes portrait images to post as landscape. We have added a warning to the image insert pop-up as well.

Motor Mount squeak & misalignment question

MomoJeep

Basic User
City
Seattle
State
WA
I had my frame checked before building the Jeep. The said it was straight. However, for one of my motor mounts the rubber block is tweaked badly out of shape in order for it to fit. it seems the misalignment is like the engine it too far forward or backward, however, the other mount is ok. Could it be a bent motor mount bracket? Anyone one else seen this problem?

Also, one of my motor mounts recently started making a squeaking sound. I'm planning to check that all the bolts are tight, and wondering if anyone else has experienced this? It doesn't make noise when the engine is cold, but it does squeak when running either in gear or coasting. With the engine off, if I grab the valve cover and rock it back and forth, I can hear the squeak.

It may seem this is related to the misalignment, however, it was misaligned for years before the noise started.

Any thoughts?
 
Just a wild guess, but check and see if your metal motor mounts are in the correct set of holes.
 
Just a wild guess, but check and see if your metal motor mounts are in the correct set of holes.
Put up pictures of it and someone can tell right away you can tell if the holes are off.

Driver side... probably the source... but double check.

100_0241.jpg


cb
 
I discovered the source of the squeaking, it wasn't the engine mounts.

By the way, the bolts from exhaust manifold outlet into exhaust pipe were "snug" but on the verge of being loose. I cranked them very tight. Then I began to wonder if that was the right thing to do. Anyone know if there's some reason why these should be "not very tight" ? Or should they be cranked very tight?
 
Here are the pics of the engine mount (passenger side) that is tweaked. I don't think it's tweaked enough to be the wrong bolt holes. I had the frame check when I started the build, and it was not perfect, but was straightened. My hunch is that the bracket that extends from the frame to the mount could be the source of the misalignment. But when I eyeball it, it doesn't appear to be tweaked. But I think it still could be, jut not soemthing that's east to see. Any thoughts on this? Does anyone else have this issue?
 

Attachments

  • image0-2.jpeg
    image0-2.jpeg
    70.9 KB · Views: 17
  • image1-1.jpeg
    image1-1.jpeg
    115.9 KB · Views: 17
  • image2.jpeg
    image2.jpeg
    84.4 KB · Views: 17
Check to see if the trans mount is in the correct holes. If you unbolt the trans mount and slide the trans toward the pass frame rail (it wouldn't take much) it would center the motor in the frame rails. Kinda looks like the engine/trans is slanted toward the driver side.
 
The trans mount holes look correct. However, where the x-member mounts to the frame could be adjusted.. There are slots there but someone seems to have re-drilled some holes...!
 
If you disconnect at the mount and try moving toward pass side. May only need 1/4" to 3/8" to bring in line. Also your skid plate bolt holes are probably slotted. You may have enough in the slots to move the rear of trans/transfer case toward pass side. It may take some of the twist out of the motor mount. If you do this, check your front drive shaft and clutch setup to make sure their is no binding or hitting.
 
Back
Top