
Give me a bit and I'll try to get photos for you.Scott, Do you have any pictures of the frame of your half soft top? Is it a factory soft top? I have most of a frame but need to know what all I am missing.
Thanks.
Paul

Check out https://www.cj-8.com/threads/oem-levi-blue-1-2soft-top-in-se-pa-950.45439/
It is one I sold and I think it had all the parts. The silver flat parts are to use hard doors with the soft top.
Each side L/R has one hole, correct? That's the way it should be - the horizontal bar plugs into that hole, the hoop sits just aft of the seats and just fore of the bulkhead.Thank you for the pics. I think I have everything except the brackets. Which I can buy, But my rear hoop isn't quite right because I only have one hole for the pins in the horizontal bars. SO not sure if this is a different part than original. Now to find a place to fab the canvas portion.
Currently out of the tub mount brackets but can cast more if asked. Now that the 3D printed ones are out there, I stopped casting more until I need them on my own projects or I get a request for them.Kim has the windshield mounts listed in ebay in bronze(may have tub mounts but not listed currently). BRKLYNZ28 has windshield and tub mounts in what I assume is 3D printed plastic.
Anyone have an idea of the strength of the 3D ? Seen a few items made but never seen it testedCurrently out of the tub mount brackets but can cast more if asked. Now that the 3D printed ones are out there, I stopped casting more until I need them on my own projects or I get a request for them.
I have a set of @BRKLYNZ28 's shoulder belt pucks. They seem to be holding up OK for the past 5 months, but I don't plan on leaving them exposed in the summer sun much.Anyone have an idea of the strength of the 3D ? Seen a few items made but never seen it tested
I am kinda embarrassed I had the bar put together wrong the other hole is there. too much fumbling around. HAHAEach side L/R has one hole, correct? That's the way it should be - the horizontal bar plugs into that hole, the hoop sits just aft of the seats and just fore of the bulkhead.
Edit - looked at your picture, the one side doesn't have a hole, you're right. Might have to punch it, it could be hardware from a different top.
You'll also need the windshield mounts, which Kim also sells.