Rock-N-Roll
Legacy Registered User
- City
- Colorado Rockies
- State
- CO
Rock-N-Roll
Excuse my ignorance but what and where is my intake system?
I have attached a photo with a high lighted area - is this it??
Thanks.
Your question regarding the photo is correctly answered above, (by Spankrjs).
I am/was referring to how your engine is supplied with intake air for combustion. If you have an unprotected aftermarket air cleaner, (such as a K&N) or a stock air cleaner that does not have the rectangular intake hose attached.........road spray/rain can cause the type of problem you described.
It won't hurt for you to put a small amount of di-electric grease inside each spark plug wire - at both the spark plug end and distributor end.....as well as the coil wire ends. (does the same thing as WD-40, but is a more permanent moisture barrier. If you have any cracks in your spark plug wires, its time to replace them.
Is there any way road spray/rain can get into the distributor between the cap and distributor base? You can make an inexpensive shield by putting a piece of duct tape around the joint. (I don't know what type of ignition system you have.)
Not being there, all I/we can do is throw out ideas.
