Random Post Thread (aka: increase your post count here!)
- Thread starter rustycrawler
- Start date
- Status
- City
- Gonzales
- State
- La
Here is the bad part of having a plasma cutter. The electrode and tip cost close to $30.00 a set and when you are cutting rusted, dirty or trashed up parts you can go through a couple sets in less than thirty minutes. In those cases I still use my gas torch. But there is still nothing like a GOOD plasma cutter.
mysunnshine
Legacy Registered User
- City
- Phoenix
- State
- AZ
Sent from my SM-G920V
- City
- stafford
- State
- va
I need to work on cleaning stuff like that
- City
- Ashburn
- State
- VA
I find it hard to believe that no one found my right foot to be sexy.
Back to my build now.
Well, I was afraid to say it, but ...... It looks better than my nose pic!!!
- City
- Landing
- State
- NJ
Jim nice work but you need a dedicated build thread 
- City
- Landing
- State
- NJ
Barry are you at Jeff Daniels today ?
- City
- stafford
- State
- va
Jim nice work but you need a dedicated build thread
I think your right , I'll see want I can do
It's been several months since I've been able to work on it
PetesCj-8
CJ-8 Member
- City
- slatington
- State
- pa
No one wants to see a nose pick. 👃🏻👈🏻😯😂
- City
- Ashburn
- State
- VA
Ba dum dum crash!!!
mysunnshine
Legacy Registered User
- City
- Phoenix
- State
- AZ
That was a serpentine belt set up I built on a 1949 Plymouth flathead 6cyl so it could have an alternator and an A/C compressor. 
Sent from my SM-G920V
Sent from my SM-G920V
- City
- East Norriton
- State
- PA
No I did not go, did you?
- City
- Landing
- State
- NJ
No I didn't not
- City
- beaverdam
- State
- MI
I find it hard to believe that no one found my right foot to be sexy.
Back to my build now.
If that is your right foot, you must dance like you have two left feet.
PetesCj-8
CJ-8 Member
- City
- slatington
- State
- pa
The attention to detail on this site is amazing... And in this case amazingly disturbing. 😉
- Status