- City
- Flagstaff
- State
- az
Ah....
Is there any reason for those swaybar drop brackets? They aren't part of the RE kit, were they on there with a previous lift?
Your swaybar links are longer to make up for the lift, so they're leaning well back because of those drop brackets. Stands to reason that your swaybar links are rotating between the pivot points rather than actually actuating the swaybar properly. Hold a pencil between both hands with the pencil vertical. When you move the lower hand up, it's going to push the top hand up. Now put the pencil at an angle like you have on your links and push the lower hand up, the pencil is just going to want to rotate in space.
This effect is enhanced because the links are leaning rearward. The axle is going to move forward as the suspension compresses, moving that end of the link forward as it comes up. I think you're basically driving it as if there's no swaybar at all.
I'd put the swaybar back in the stock location, and get some new polyurethane bushings to swap in at the same time while you're at it and see what that gets you.
My scrambler didn't have a sway bar when I got it, and when I picked up the sway bar I think I got those brackets, and not knowing any different I connected them. Should the swaybar be mounted to the frame and not dropped by those brackets? if that is the case I could see that having an impact. The sway bar disconnects at the end of the bar are from the RE lift kit, so I think they are supposed to be on there, right?
Thanks again for the input



With that sway bar, you don't have to disconnect it when you go wheeling because it will not limit travel with your RE springs.......







