84jeepscrambler
84 Scrambler 68 Mustang
- City
- Kutztown
- State
- PA
I am still performing the tub off restoration of my 84 Scrambler (258 I6 to 360 V8). I lowered the rebuilt 360 onto the frame and started to put new cluth kit with the 360 flywheel and my rebuilt T176. I go to put the skid plate on to support the tranny and the holes in the skid plate aren't mathing up anywhere??? I have a total of 6 holes (3 on each side) on the frame that I thought would adjust foward for the V8 (shorter block) then the straight 6... When I set the skid plate in the forward most position the plate misses the holes by about an inch... The plate hangs about 2 inches outside the frame on both sides??? Do I need to cut the skid plate???? It is the stock skid plate from looking at others...
Thanks
84jeepscrambler
DAN
Thanks
84jeepscrambler
DAN

