• Notice for iPhone users: DO NOT use the image size reduction option when uploading photos to the forum. This causes portrait images to post as landscape. We have added a warning to the image insert pop-up as well.

Speedometer gearing, FYI

jscherb

CJ-8 Member
City
Elmira
State
NY
This past week I swapped in some 3.54 axles, finally got rid of the 2.73 turkeys that came from the factory.

This was also an opportunity to get the proper speedometer gear so my speedo would read accurately. I've got Goodyear MT/R 31x10.50's, and it seems there's no gear that can make the speedo correct with 2.73's and that size tire, so my speedo has always been way off.

I visited all the speedo gear calculator sites and most of them recommended a 31 tooth gear, one recommended a 32 tooth.

Before ordering the gear, I compared the indicated speed on the speedo with the actual speed as shown on my handheld GPS. The speedo indicated 10% faster than the GPS, so I figured I needed 10% more teeth than my current gear, which was a 27 tooth. 27 + 10% = 30 tooth.

I installed the 30 tooth gear today and checked against the GPS and the two were exactly precisely the same at all speeds. This is more than I can say for my stock TJ with factory tires :-)

So there's two FYI's for everyone:

1. The gear calculator websites are close but your situation might be slightly different, so if you have a GPS, trust that before the calculator sites.

2. I got the gear from my local Jeep dealer for $10 plus tax. He ordered it and it arrived the next day. One of the major Jeep catalogs sells these gears for $24.99. Who woulda thunk that the dealer would be so much cheaper than the Jeep catalog? Pays to check prices I guess.

All this just FYI.
 
One of the problems with using the gear calculators is the tire size. A lot of people use the tire size on their sidewall, like your's say 31. You need to actually measure the height. My 33's are really only 32" tall. My speedo gear change put me pretty much right on.
 
Thanks

Good information, thanks for posting. Right now mine is off around 20% but i rarely drive it on the highway, still i might eventually do something about it.
 
I keep a little handheld on the dash. I have 31's. My speedo reads slow but my odometer reads right on with the GPS. Can't figure that one out. My speedo needle sways back and forth so much it is hard to tell what it is reading for sure.
The circumference of the tire will determine how the speedo reads as that is how far the Jeep will move in one revolution of the tire. If you know the diameter, you can calculate the circumference, or just measure around the face of the tire.
Bob
 
Not hijacking the thread- but if you want you speedometer needle to quit bouncing back and forth- grease the cable(need to unscrew it from the back of your speedometer). This should help it get more stable for you.
Best of luck.
Kyle
 
Thanks Kyle,
I have the dash loose now as I'm doing the blower motor upgrade. I will give it a try.
Bob
 
The GPS is a great idea. I need to do this and never thought of using a GPS. Good info.
 
Back
Top