- City
- Claflin
- State
- KS
I'm in the process of installing an AMC 360 V8 in place of the 258 in my '84 CJ7. The Jeep currently has TF999 automatic transmission that was rebuilt about 15k miles ago. Ever since the rebuild of the transmission, it has been hard to shift out of park. It goes through all of the other gears just fine and even goes back into park normally. The issue is just when trying to shift out of park. I had a B&M ratchet shifter in the Jeep before and just chalked the hard shifting out of park on the aftermarket shifter. You had to slam the shifter pretty hard to get it out of park. In the course of the 360 swap, I have decided to go back with an original tilt column shifter so my wife can drive it easier. I am using an Ididit column cable shift linkage setup. Got the cable column shifter installed and and still having the same hard shifting out of park I was having before.
The cable is adjusted and lines up with the gear indicator correctly and shifts fin in all other gears. When I disconnect the cable and try to manually move the lever from the park position, it is still really tough to get it to shift out of park. This leads me to believe it is something internal. Is there some sort of internal adjustment on this or could there be an issue with the shifter detent in the park position? I have been searching for hours and cannot find anything similar to the issues I am having. Anyone have any ideas on what could be causing this and were to look on how to get this fixed? Jeep will be ready to run in a few days but want to get this taken care of before hand. Any help is appreciated!
The cable is adjusted and lines up with the gear indicator correctly and shifts fin in all other gears. When I disconnect the cable and try to manually move the lever from the park position, it is still really tough to get it to shift out of park. This leads me to believe it is something internal. Is there some sort of internal adjustment on this or could there be an issue with the shifter detent in the park position? I have been searching for hours and cannot find anything similar to the issues I am having. Anyone have any ideas on what could be causing this and were to look on how to get this fixed? Jeep will be ready to run in a few days but want to get this taken care of before hand. Any help is appreciated!

