• Notice for iPhone users: DO NOT use the image size reduction option when uploading photos to the forum. This causes portrait images to post as landscape. We have added a warning to the image insert pop-up as well.

Tranny Options?

x10 on the AX15. Plus, if you want to do an EFI upgrade later the crank position sensor hole is already there. Just use 4.0L flywheel when you install. Beats removing trans and machining later.

Sent from my LG-P769
 
There are no floor plate or floor board mods to get an AX15 in, because the shifter is in the same hole. This is a stock t5 plate without any mods (a SR4's plate should be the same), an AX15, and a twin stick 300:



If you use the AX15, you want 96 and newer for the external slave cylinder. I would guesstimate a AX15 swap is going to cost you $300-$400 more (adapter, driveshafts, etc.) compared to the t5.

x10 on the AX15. Plus, if you want to do an EFI upgrade later the crank position sensor hole is already there. Just use 4.0L flywheel when you install. Beats removing trans and machining later.

Sent from my LG-P769

Thanks for the information:thumbsup:

I will be looking into this swap very soon, I blew up T5 #3 the other day:crazy::(:banghead::evil:
 
What about the starter? I seem to remember The Boy going to the smaller Mitsu starter when he swapped out the T5 for his NV3550. Got a new bellhousing too. I think it is different from the AX-15 one. Clocked the D300 with a ring from Novak, IIRC and got the hydraulic clutch parts online from Parts Mike.

Sounds like the AX-15 might be a little easier.

This is on my radar, too. Our Scram will be growing a few OMEmu inches from stock and intend on 4.10s with 32s.
 
NP 435 Behind a 258 EFI, D300, 456 gears and 35', Need different clutchdisc, the right bell housing (I used the one that came with my T5 drilled the new holes), and adaptor to D300 and drive shaft mods. One tough trany. Grany 4speed. Can still run 70 on the highway.
 
Back
Top