Okay, so my experience .. really not as bad as I thought it might be; no broken or seized bolts. A few hoses we just cut instead of properly disconnecting, but they are slated for replacement anyway. Here is my final version of the list, with notes:
I didn't include taking the windshield off .. which was pretty easy actually.
__ Dash pad
> - didn't have, so no notes.
__ Dash board
> - It is
best to disconnect the harness/fuse block and leave gauges and lights intact. The only trouble with this method is the harness is laced between the steering column and top of the dash - for me, I had to remove the bolts that held the column to its mount. Also, you have to remove the high-beam switch.
__ Wiring harness
> - See above. There are several anchors that hold the harness across the firewall, a single wire attached to the heater fan (engine compartment).
__ Steering column
> - single bolt just above spline inside engine compartment .. PB basted it, released with a tug. Harness has to be removed just above the column (inside). A few bolts at the gasket in which the column travels though the firewall. (don't forget the bolts that hold the column up to the dash (inside).
__ Clutch linkage
> - remove carter pins and washers from clutch linkage; both sides of firewall, remove linkage.
__ Master cylinder
> - remove and seal brake lines, drain fluid, release clip for brake pedal linkage from inside. Remove bolts at firewall - which also holds the brake peddle assembly in place. Clutch linkage has already been removed, so now the peddle assembly can be removed.
__ Charcoal Canister
> - forgot about this one .. pretty easy, but removing it includes removing the fender braces to the firewall.
__ Throttle cable
> - Release cable attachment at gas peddle and fished though firewall.
__ Seats
> - as easy as it seems.
__ Center console
> - Didn't have one; no notes.
__ Emergency Brake cable.
> - Release cable attachment at peddle, then detach the cable underneath the body just in front of the rear axle (single bolt).
__ Fill and Vent hose
> - Remove at tank. See evap notes below.
__ Evap Lines
> - These come from gas tank and travel through a body brace to driver's rear quarter - we just cut'em.
__ Roll Bar
> - as easy as it seems.
__12 body mounts
> - There are two less obvious body mount bolts hidden between the fuel tank and the rear axle .. only difficult ones (sorta).
There were only two of us, so it was a bit tricky lifting the body off the frame without a hoist (you can see us using a ratchet-strap to hold up one end of it
Also, be prepared to accommodate the edges of the body, as they are lower than the braces which support the body.
Overall, a lot of fun!
.